View Full Version : 1st Gen. Ram - All Topics
- sorry to do it first gen guys but i gotta rant
- Will 19.5s fit
- truck loseing acceleration
- BD cooldown turbo timer installation help?
- How to get more fuel screw: My Official Redneck Way.
- tail & Running lights on relay, how?
- 134a swap kit?
- Fuel Tank Question
- need another first gen
- can i use the bleeder bolt in the injection pump?
- Shackle Flip for safe suspension lift.
- d250 2 wheel drive measurements
- fixed my u-joint
- Changing pump settings for towing?
- gauge system
- Engine temp
- Time to admit defeat
- Made another hook`
- VE Pump....Oooops.
- fan clutch removal
- which transmissiion in stock 93
- transfer case
- gauge location
- fuel pressure regulator
- block numbers
- Help, Truck Stumbles
- tips on gettin shut off solenoid out?
- Pod injectors?
- throttle valve?
- 727 vs 518 behind 4.11 gears?
- HELP! I think I messed Parker's truck up...
- Downshift when stopping or neutral and brake?
- mechanical oil pressure gauge
- tranny cooler lines
- replacing block, need advice
- quick vaccum booster ?
- HVAC vent selector/ vac control system
- 2nd gen body on a 1st gen chassis
- Ground issue
- Good thing I had a spare.......
- Got a cummins again
- Please recommend a mechanic in SF Bay area....
- converting auto to standard...help?!
- oil pan gasket?
- Need help with Parker's truck
- 2nd Gen Rims/ D61/71 Axels
- Shut off solenoid fix?
- Resto update
- Video of my lastest pull with carnage
- Bad Steering Box?
- 92 Died, Just Shut Down!
- w350 dually brake rotor bolt torque spec
- Dead KSB symptoms...?
- Door Adjustment Quick and Cheap
- Windshield wipers quit!
- what fluid to us on tranny
- front pads and rotors
- VE fuel pin quick question
- Holset H1E
- Wheel Simulators - Need Advice
- Quick Question, axle nut
- No overdrive? Any ideas?
- Vibration on highway when I go from accelerating/maintaining to coasting
- id like to thank smokinblacky
- 1stgens pulling at Wahoo NE
- Dual stick np 205
- clutch
- quick question
- 12 wastegate housing back plate gasket?
- Borgeson install, Is large Spring needed ??
- cargo shelf behind the seat
- Electrical problems
- 1/8th mile VID.........
- charging system and A/C act up when hot
- 6" Skyjacker lift drivers front major sag????
- od plug/sensor
- Ran the 1/8th finaly. Not totaly bad news......
- body grounds
- Found some good Holset specs
- Dually rims....
- Electric Fan Recommendations?
- Fuel sump
- 2nd generation wheels on a 1st gen : generic lug nut part number
- it works
- 1989 2wheel drive converted 4wheel drive?
- limited slip swap & rebuild
- Wiring Harness for our trucks
- Are people nuts???
- Stupid truck makes me wanna kick it.
- wiper motor woes
- Shortening oil pan sump??
- auto to 5 speed
- STICKY worthy? Color codes w/Pic
- cab
- 6x6's
- D250 to D350
- to Intercool or not to intercool that is the Question...
- Radiator Tilt Back (electric fan clearance)
- Say it ain't so!! Bought a Second-Gen...
- 6.7 water/air
- thinking about going fully synthetic everywhere...help me out
- A/C cycling sw.?????? HELP!!!!
- Who says 1st gens can't walk on water?
- what to do
- need a PcM
- Plow possibility
- injector bleeding procedure ???
- Puzzling Dipstick
- 2 problems need urgent fix.
- need help with a intake idea
- looking for a complete rear rebuild
- Are crack blocks an issue?
- HVAC fan has gone intermittent on me
- Alternator gauage discharging
- No charge, OD, A/C, WTS Etc.
- Disk backplate or not?
- got pictures?
- clutch or tranny
- Injector ID
- phantom shifting - overdrive/tps ghosts?
- 89-93 Dodge
- 6.7 & 5.9 VE Questions
- recore or go new
- I was right, almost
- Wait to start light flashing
- 6.7 Liter
- installed 366 and now now shutdown
- need a fitting to make oil feed line for turbo work
- Torque Links
- A/C Fan on high quit working
- Good Old Warhorse
- 93 Shutdown
- 93 owners manual
- other trans/valve body adjustments???
- Hey guys as you know.... Conversion
- Eliminating the Crank sensor
- injector and manifold questions
- Engine Temp Issues....
- Need a part number
- grid heater
- Truck is back in pulling attire
- New addition, LOTS of questions
- desperately in need of some part #'s and where to get please!
- front end width?
- Boost elbows...?
- 2nd gen lift pump psi regulator
- Quick 47RH install question
- voltage issue
- AC condenser
- tire/lift?
- Little better track.
- Hard starting issue.
- 1st gen exhaust
- Speedometer
- EGT temp question
- Rear brake upgrade
- VSS wiring
- somethings wrong in overdrive
- Is this the borgeson Shaft part # ?
- Injector question
- Window replacement
- 21.8 Mpg!!!!
- Crew Cab parts.........do they make them?
- Cleaned out the HVAC today...think I found my problem.
- 1993 dodge w250 4x4
- New headliner
- light troubles
- rear cab speakers
- Alternator/starter troubles?
- Body Mount Kit
- Couple pics from the track yesterday
- underhood light bulb for '93?
- hp question
- VE Pump Timing
- dodge ram trim (1990)
- loose drive shaft diagnosis
- Need instruction
- A/C Defrost noise
- New Radiator overflow system
- Dana 70 ls question
- Disapointing night at the track
- Why doesn't my AC cycle?
- Front inner seals leaking
- early christmas
- Another funky noise.......
- 1996 Dodge Ram 2500 V-10
- power door locks
- huge lifted 1st gen
- Where should I set the toe-in?
- ebrake and abs
- Door Hinges
- exhaust question
- Bypassing SMEC questions??
- Anyone know how to identify this s300?
- best rotors and pads?
- i/c compressor housing 90* cast elbow...
- Transgo vs fairbanks shift kits? Stg 1? 2 ? 3?
- cab swap
- 2 batteries. Isolator? solenoid? switch?
- 351 VGT Turbo Question
- 03-07 8 lug GM wheels?
- u-joints
- down pipe
- I got an offer on my truck
- Rear brake adjustment issues
- Rear axle width
- Rotary drag truck build
- Quick EGT ?
- VE is a VE ?
- another speedo question
- Portland Or. NDRDA at PIR Saturday
- OK..Metal shavings in VE pump....
- Lift pump volume test
- 60mm Compressor Wheel
- Southeast Michigan VE builder
- truck got backed into : (
- Cab interchange.
- air conditioning and cooling system
- Brakes act funny
- Injection pump problem
- Is a first gen 1/2 ton bumper interchangeable?
- Help diagnose this annoying in cab noise..
- 91 Non-Intercooled/92 Intercooled merge?
- Best injectors and mild turbo upgrade for towing 93 1st gen
- exhaust and turbo gaskets
- speedometer
- truck tried to die today
- Matt broke it.....
- crew cab on a 93' club cab frame........can you do it?
- fuel line question
- 4" Exhaust Install
- Rear axle nut socket
- Speedo quit.....
- ProCharging a Cummins
- Where to buy a front hitch for my 93 dodge 350
- VSS gear ratio
- Installing valet.. what is the banjo bolt threads
- dual VE's
- Ramcharger Re-Power (Project Cummcharger)
- Weekend project done
- 01 quad cab seat in 91 reg help
- Did more damage than I thought
- manuals....not for drag racing
- A518 - upgrade to lockup? + general automatic questions
- Fuel gauge question
- Tps
- Larger replacement fuel tank
- Hazing Issue
- 1st gen accessories
- O/D and Cruise I've got...no Speedo