View Full Version : 1st Gen. Ram - All Topics
- 210 degree tranny temp while towing.
- Rear diff Chatter
- Intercooler
- Turbo help
- Dana 60 outer stub shaft
- Ahh, the memories...
- Dana 70 Rear End Interchange Question
- Pyro Amp Box
- 1979 cummins conversion pics FINALLY!!
- Hub Help!
- Need More Ponies
- this is odd
- Truck took a hit
- Factory paint color code
- Brake Controller
- transfer case.
- *Newbie* Need a starting point
- A lesson about quicky wire taps.
- Where did my fuel mileage go!!!!
- Speedometer randomly stops working
- dowel pin
- fuel supply or what
- Front Brake Pads
- Guages acting crazy
- TV cable
- Disconnected Anti-lock
- IFP o-ring question
- Diesels and high RPM's?
- speaker size
- I need an Odometer
- 3" to 4" V-band adapter? Do they exist?
- under hood insulation
- First UOA on the CTD
- Injector Pump Leaking
- Big Fuel Line Upgrade
- Another Ebay find....just dreaming
- 2wd front end ?
- finding a D60 axle shaft
- New Radiator
- Tranny Issue
- Had to Settle
- HTT Stage IV question
- exhaust size??
- need help, removing injection pump
- How to add 2nd Gen / 3rd Gen Towing mirrors to a 1st Gen CTD
- Front suspension
- KDP killing
- Allison Trans. In Our Trucks !!
- Has anyone used a 2nd gen. exhaust on a 1st gen?
- Ferd I/C vs. Water/Meth
- Helppp
- Not Cool!
- 6" intake
- New weak point.
- TST Dowel Pin Fix Kit
- Best place for headgasket?
- Heat Problems
- Axle repair
- Cool Running
- Other Exhaust option (S.S.....
- Anyone coming through SE Ohio for the Kentucky meet?
- Turbo Oil lines
- What is a fair price?
- :) finally
- Trailer Light/Brake Wiring
- egt ?
- Tail Gate Latch.. Help
- What's the safest way to pull the engine/trans?
- Putting 2nd Gen Mirrors on a 1st Gen.. ( PICS)
- Question on Borgeson
- fuel pin
- I finally did it.
- disc conversion less than $260
- check engine light
- Heating up issues
- Electrical Problems !
- HELP...No/LOW boost with new VE pump
- '92 Cummins Ramcharger?
- Non IC 1st gen
- Any 1 gen rigs MACCO'd
- My New truck
- Any of you have falts since the 3200 GSK install?
- adapter plate part# needed
- 94-up exhaust system?
- Washing the engine
- Remove dash & radio
- What would 1st Gen, America look like?
- Power steering pump install?
- got new tires now steering feels loose
- Fuel Tank Straps
- My old stinky truck whooped a 2006 Porsche Carrera . . .. .
- am i the only one?
- Newbie
- 2wd front brake torque specs
- A 12V for $500???
- bully dog exhaust
- Saggy Springs or Bent Frame
- Preventative Maintenance?
- Power steering oil cooler questions
- My pics are finally in
- External Voltage Reg
- Battery terminal question
- Help, need NAPA front rotor part #'s!!!
- Take a look at this!
- Going from straight-piped 3" to peacefullness!
- Anti-skid light came on!!!
- It only starts when it is hot.
- Injectors, injectors, injectors
- trying to get the rotor off
- Power steering pump question
- Exhaust Housing Part Numbers
- Power steering pump gear, shaft needed 1990
- Installing Cruise Control
- Firm your brake pedal with wire braided hoses.
- couple odd electrical Q's
- Speed sensor question
- Crankshaft seal??
- Starwheel ???????????
- Stan's 4" Exhaust with a HX-35
- Squeak squeak squeak...
- Ok, What is your goal(s) for your truck?
- is it worth my time
- fast blinkers
- A518 shifting
- Pump Timing - several questions.
- How many yards are our beds?
- So close in posting my pics-need help!!
- Who makes a SFI flexplate for a 518?
- Stock Radio Upgrade?
- digital gauges (monitor)
- All I did was clean the battery...HONEST!
- removing vacuum pump
- the best auto
- which automatic
- Rear Dana 70 Power Loc
- US Gear D-Celerator Exh. Brake?
- Replacement latch for sliding rear window?
- Cruise Control Surges???
- p7100 upgrade
- Did the kingpins, still have death wobble.
- Ok, Need some help here (Going on a trip)
- tail light problem
- Brakes to the floor
- Front end rebuild, where to get QUALITY parts
- Major Problem, need advice/help??
- Need help troubleshooting white smoke!
- Home built rear spring hangers
- Who's going to Bowling Green, KY (TS Outlaw Race) May 12?
- 1st Gen vs Duramax
- gauge question of sorts
- Turbine Housing Question
- 93 Performance questions....
- Guys How do I show a map and post it the site ?
- hey dp??
- dyno runs
- I think that did it Wanna.........
- new issue??
- stupid??
- over revving Big time,please advise!!???
- How quiet is your rig?
- Mirrors Won't Stay Put
- KDP blocking tab Kit for the 93's
- Crankcase vent
- a few questions......
- Last Call: Eastern PA Spring Meet May 13th
- How much did you pay for your first gen?
- Somebody goofed ......
- I call B.S.!!!
- Boost controller location
- Anyone painting their engine compart?
- Keep blowing voltage regulators...HELP!
- injection replacement schedule
- HTT stage III vs 12/16cm or both?
- Help out a Newb...
- auto tranny opinions
- Where to buy 4" muffler NOW
- Fuseable links VS fuses
- Piers ????'s
- Drill bit size for 1/8" NPT EGT probe
- 2nd gen overdrive switch info
- Help
- Wheels
- tell tale signs of rotten Lift Pump
- TransGo Shift Kit and Seals
- 1st gen Mexican commercials
- A few problems
- My truck at work!
- NV4500UHD conversion? and SBC dual disk 3850 comp
- Ground Pin = Weeeeeeeeeeeeeeeeeeeeee
- Weed Eater from heck!
- Where to get a 1st Gen Cummins
- Rusty Rocker panels
- 3" Brake shoe swap
- Poor mans Bhaf cover
- Questions on the steering shaft
- Custom 4" Exhaust
- Graduating College
- white smoke and low idle on starup
- Vaccum pump swap on non-ic truck
- guages HELP!!!!
- speedometer
- 3200spring?!
- My turn for headlight switch meltdown
- "What in the heck is it????"
- Interesting statement-
- One Way to Install a Powerstroke Intercooler
- Bleed RWAL HOW?
- Jardine Exhaust
- no power low boost
- Preload nuts (axle)
- Well You Did It
- Help, electrical system cooking battery.
- ticking sound
- need rim help between 1st and 2nd gen's
- Low voltage reading...questions???
- What work needs to be done on a 93?
- Front air bag specification info needed
- Cheap DODGE 150 for parts if anyone needs parts truck
- smoke & boost
- quick abs question
- Foggin a Ferd?
- Nylon fuel pin washer thickness?
- shift kit
- Do I need a Third W/M Nozzle?
- updating to a Borgeson, but which one
- shake ?
- PDR goodies ordered but trans cooler concerns
- Blower fan doesn't work HELP
- Spline count please...
- towing auto
- 1900 mile road trip and the issues that came up
- Intercool Whys
- 1st Gen Aouto Tranny Guys (some Advice Needed)
- Strange Fuel Bleeding Experience
- Anyone looking for a cheap 1st Gen. ?
- Clutch master cylinder stuck??
- Anyone put a 5" tailpipe on a first gen?
- NipponDenso Alternator Regulator
- splicing a fuel line?
- Boxing the frame
- HydroBoost
- Gauge Score!
- Automatic... toast or stupidity?
- Powerstroke Intercooler Fits!
- U-Joint question
- Smokier than usual...
- U-Bolt Preference?
- Alcoholics
- Genuine Old Smokey Fuel Pins- Where to purchase?
- What's the deal with the seats??