View Full Version : 1st Gen. Ram - All Topics
- Help!! What Happened
- Ground Fuel pin and nylon washer? is this supposed to happen?
- Biggest tires under a first gen?
- Can someone explain what a 3200 spring does
- Saggy door...
- Belt Idler question
- 4x4 Shifter Boot
- revamp
- Finally got the bhaf!!!!!!!!!!!!!
- stack box plumbing.
- Need advice on selling my rig
- need help with my new Hx-35/12cm setup
- Tryin to learn about 1st gens
- front bumper
- A Little Confused...
- Cab lights
- Where to buy 3200 spring
- Power steering pump?
- 2nd Gen. seats in a 1st Gen. ?
- Anyone want to take a picture for me? PLEASE!
- Converting a Auto to a NV4500
- Please help to diagnose the clunking noise
- 2nd Gen. Ranch Hand
- 1ST Gen tranny/2nd Gen Motor
- tranny cooler
- tiny tach or no?
- New Truck, New Problems - No OD
- Injection pump mounting studs....
- boost guage?
- OK guys im looking
- Upgraded Fuel System Part Numbers?
- Im huntin' stack pics...
- Valet switch ?
- spent some money this weekend
- 2 kdp's killed today!
- My Dad is Buying a First Gen
- Hood stack... Flames... VIDEO!
- Crossover tube
- break blues on the floor help
- Injection pump Part # ?
- fuel tank straps
- Getrag's out, ......New Clutch
- Charging system issue
- bright light indicator
- Moving the down pipe
- Ready for winter??
- 3200 spring help
- Hood stack has me worried about motor mounts
- Another gauge question
- dyno sunday
- Got 6''?
- installing new injectors
- Skyjacker front springs, new steering box mount
- The night the lights went out
- all dressed up and no where to go
- Borgeson rag joint install questions
- another kill story
- Brake Pedal problem
- Cooling/Overheating questions
- Electrical/Fuseable Link Issues
- turbo shaft question?
- gauge gizmo
- Stepside longbed 250 4x4 91????
- help! back seat options
- Not going back to center
- Signs of injection pump needing rebuild
- No smoke???
- Holy Crap !!!
- fuel pressure
- Odometer Issue
- turbo compressor wheel not spinning?
- Service Manual Question
- Dumb Ford guy question
- Fuel Leak
- Well that worked out sweet!
- What about the EGT'S?
- $127.00 hinge
- plug in connector
- Htt ???
- Disconnected w/g is it bad???
- got fuel, need air
- Rear Gear
- Check the manual !!!!!
- 518 issues w/ reverse
- empty weight rear tires '92 W350 srw
- will turning the starwheel give me more boost psi
- Headlight Relays with a twist
- Aim Or Aol Messenger. Anyone Have It?
- 24lbs of boost = ? horsepower and ? torque and another question...
- Should I try a 12cm
- Looking at a 91, 2x4 with auto and gear vendors
- injector pump rebuild kits?
- 1st Gen Donor Trucks ?
- How do I post pics
- Pacbrake From 92. Will It Fit A 97
- Speed-o-meter
- 3936320 walbro PSI
- help: smoking at idle
- 1st gens with 19.5's
- Clutch slip
- Vote for a 1st gen!
- CHEAP 92 EXT 4x4
- 4 door, Really nice
- Aftermarket Wheels
- Restore?
- first gen turbos
- this months DTR winner
- Please Help!! I think I blew my Tranny
- how much more power buy just flipping the fuel pin
- bad vibration only at idle???
- UH OH! fuel filter housing threads are stripped
- removing old injectors
- bullyog fuel pin dimensoins??????
- Bully dog injectors?
- Diesel Drip
- ? Yoke To Yoke ?
- Banks Twin Ram???
- Pre-Bent Brake lines
- Banjo Bolt - Where to buy one
- Brake Caliper help!
- 3.55 vs. 3.07
- Boost gauge installation on a 91.5 - 93
- Hydro boost units, who's got 'em?
- How good is the A727 auto trans.?
- stack is on...
- Steering Question
- Manual swap
- Throttle actuator rod.
- Upper control arm
- intercooler
- cheap exaust break
- More MPG questions
- 4x4 light
- cheap lift kits
- Pumping for PODs
- overdrive problem
- new to cummins
- Crazy City of Phx Auction Prices
- A Few DUMB questions
- Steering box queston
- Need some direction please..
- how much
- Project started
- remove injectors?
- 93 with brown IP - worth it?
- injectors and turbo upgrade
- Injector port size
- Flexy stearing box
- Tach Help
- how much can i?
- turnout of first gens was TERRIBLE at the nats
- 1st Gens, how much hp?
- HAHA heres a chuckle
- "clicking" sound, what is it?
- Noise police
- Getrag Or Notrag (np205?)
- Picked up the new truck lastnight...
- quick voltage regulator question
- Calling all tach installers!
- getrag clearance...
- 1991 Non-Intercooled Cummins
- which manifold?
- Muffler? What muffler?!!!!
- Whining getrag in 4th and 5th only
- On warm up she gets hot and then goes normal
- gasser body swap
- KDP- "killer dowel pin"??????????
- squeaking under the hood...fan???
- Fuel Pin
- Over Drive
- better springs
- electrical gremlin
- Water/Methanol mix cloudy?
- ticking noise.
- Got A New Truck Tonight
- Manifolds?
- just curious
- Quick coolant ?
- 6v53
- gone
- I've been wanting a ctd ram for a while now,
- Bhaf?????k&n??????
- new first gen owner!
- Transmission swap
- some wh1c questions before the weekend
- Pretty sure I need a new tranny, what do you think?
- Stalling, running rough?
- Tires for Alcoa wheels
- fast blinkers//trailer lights
- Getrag to NV4500 Question
- K&N air filters........are they really bad for my engine?
- Cold Starting without Block Heater
- Grid Heater?
- squealing belt
- radiator
- 96mph 1992 3/4 ton
- need a hand
- Just a little rust
- 2WD Front Springs PN
- Weird KDP question
- How fast? How far?
- New decal
- voltage reading
- pics of my 91 i had
- Anti-lock rear wheel brakes
- Strut Rods
- Gas gauge? Sending unit
- New lease on life
- Build Me a Tranny!!
- Very very hard break pedel
- Intercooler Options
- stalls in reverse
- Radiator Fan HELP!
- New Engine, gauges, injectors turbo housing boost only at 20psi... Feedback please
- Gauges on the way...
- Tie rod ends
- 2wd to 4wd
- new gauges!!!!!!!!!!
- Question about my new Hx-35/12cm exhaust housing
- intercooled or not to intercool
- How to hold the fuel tank up?
- Brake Booster/Master Cylinder Questions?
- Hi all dang forum saz i need to say hi
- gauges bouncing around????????????????
- Cost of intercooling a 89 non/ic 350
- Wiring harness
- Roll Pan Bumpers
- Gauges acting screwy????Help??
- intake stack 1
- Help with my new Radiator
- Factory Tach?
- Help - Parking Cable Retainer Clip
- VIN # question
- Gen One Power Gains
- Would this fit a B motor VE?
- access hole for 5 sd
- installed HX-35/12 wg turbo
- hey dtr
- sweet rig in vegas
- Speedometer issues *fixed*
- Crankshaft Position Sensor
- change in priorities....
- injector install HELP bosch 190s 4 questions
- Two Optima or not two Optima?
- HELP.....leaks from the IP...still!
- Vibration has increased???
- Finally! A place for my spare tire and more!
- Engine Problems
- Shifter Top
- Grinding Fuel Pin?