View Full Version : 1st Gen. Ram - All Topics
- Variable engine noise
- Reverse/Back up Lights issue
- lift
- 93 electrical problems
- Opinions for horse power
- Volt meter all over the place
- truck not turning over
- Speedo ratio box soure....here where to get the parts!
- Injector washers
- How much weight will the bed handle?
- Is my IP going out or is it my KBS solenoid?
- Any 92 W250 owners out there
- A518 Wire
- NEW injector pump.
- need some other members opinions here....
- Advancing timing question
- Introduction and a few questions: 92 250 clubcab 5 spd
- How does 4wd work?
- Why did I lose reverse?
- Injection pump build question??
- Qualified Transmission shop.
- D80 swap
- Bosch 190 or 230 injectors?
- this is cool!! compression release/jake brake 6bt
- Happy to be mechanical
- modified exhaust housings
- Dead injector pump??please help!!!!!!!
- 97 Dodge Cummins 2 inch leveling kit install
- HELP need A518
- Blower Motor (Relay?)
- Non "cummins" parts
- ABS/Parking Brake indicator lights on - No daytime running lights
- Wipers
- ARP Issues
- Marker Lights and Gauge Illumination, but no tail lights...
- Need help with oil use.
- Gvw????
- when do you replace starter?
- 1992 cummins not holding a charge
- Tranny questions
- tired of this thing not starting!
- Transmission mount dimensions...
- king pin bushings
- brake problems ???
- Ok what say YEE
- What's this?
- Weird Problem
- Narrowing a Dana 70
- Why Did I Wait So Long?
- Got My Grille Guard Built
- Finally, Studs and Head Gasket
- Starting Issues
- VE parts
- Head Studs
- No Heat
- starter & battery blues
- painting door handles and other small parts.
- thems the brakes.
- Auto rebuild or 5speed swap
- HT3B rebuild?
- BHAF Mounting Plate
- dodge cummins flex plate replacement issues
- New IP, New injectors, Now blue smoke at idle
- Anti Theft Engine Immobilizer you can make for less than a penny
- Steering Joint Fix
- Anyone running BAE SS Header?
- New Battery
- 47rh lock without a switch
- Cost of new engine plate?
- Lockup 727
- heater controls
- White smoke, missing, and popping noise at filter and tip!!!!
- which clutch to get
- which truck to look at?
- door latch fix
- 2WD Front Disc Brake Repair and Upgrade, Pt1
- Headlight Switch New and still problems
- 1st'ish gen Father Son Project
- Your Trucks Birthday
- 1992 reg cab tranny.
- aftermarket air filter-what's good?
- Fuel line from tank fitting
- idle is hanging at half throttle
- 1989 Chicago auto show
- utility rack for trucks with toolboxes
- Transmission Toast?
- ? about timing marks and a high rpm miss under load
- manual valve body?
- Strange issue when down shifting
- VE pump throttle shaft brass bushing install question
- Fix for cargo light?
- lope or fuel knock? I'm not sure
- Air Conditioning Evaporator
- ARP Clearence (head gasket pretty much gone)
- wierd idle on cold startup
- Foam in power steering
- What's this truck worth?
- brake issues, sorry!
- piston lift pump
- Brake lines
- Truck won't idle down
- 1989 Emblems
- Transmission to adapter bolts.
- Super HX40
- Another brake problem thread
- Shocks that actually absorb shock
- Ve leaking
- Ve leak
- OH DTR gurus, lend my your screens
- need opinions on a big decision
- jim lane how would you go about this? Wiring
- grid heaters don't work
- Need 2wd getrag info...pics?
- qeastions
- calendar pictures
- Truck Values
- New Tires and Spring Pics!!
- Truck died this morning...
- Rubber floor
- Leaking Injection Pump
- Dually Rear Suspension
- Headlamp Switch on the Glitch
- calendar
- Rear pinion seal
- Pyrometer/thermocouple ??
- Eagle wheels o58
- 84 long box on a 93 cummins??
- Running ligts, dead short
- Secondary Fuel Tank
- 3200 spring,shift point?
- Engine Adapter bolt size? Mounting to a engine stand
- ft springs
- Cold, or old, tranny?
- Holey Exhaust
- Transmission Running Hot
- front spring help
- Having hard time? Overdrive / lock up 47rh install
- Throttle related problems on 93
- fuel heater wiring?
- Taillight Drama
- Fuel leak
- steering box???
- Homemade cold air box.
- My Plates Came In....
- Got my motor FINALY
- P Pump swap questions
- some upgrade help
- broken head bolts
- Water Meth kits
- diamond plate front bumper
- Cab leaks continue- help!
- Ten hour trip
- Fuel Pressure Fluctuating
- 2nd gen brake boost 1st gen master cylinder.
- In the market for injectors
- Charging question
- Tranny wont shift out of 1st...
- New head gasket - to retorque or not to retorque?
- 1992 , 1/2 ton trucks rear end codes??
- industrial injection performance calibrated ve pump
- Steering/hydroboost/brakes update
- Soft brakes, Brake light coming on
- Check this out!!
- 1st Gen. for salvage
- Why do this to HX35W?
- Pyro trouble
- Winter strikes again!!!
- $.02 needed!!!
- 2357 bulbs
- getrag rear seal
- Fuel line replacement?
- Good Bye
- Gearing questions
- What's the common point here??
- Saw a couple cummins trucks yesterday...
- GDS 60mm Compressor Wheel and Housing Install Guide
- Head Studs
- Transmission delay when cold
- Charging problem
- You'll in snow country.
- 1993 idle problems
- front springs
- Can someone please post pics of how the cruise control hooks up to the throttle cable
- post office was out to impress someone this week
- Self-2WD alignment
- What kind of tach do I need?
- what would you do if the engine was already on the stand
- No power steering
- Dually axle stud broke off
- Write-up for installing 2nd Gen Hydroboost brakes on your 1st gen
- Early Birthday Present
- How do identify rearend? NEED HELP PLEASE
- brake light wiring question
- W350 Wheel/Axle/stud Change
- Transmission Question, Where can I get one?
- Blinkers only work when...
- Are all 12 valves equal in the front end?
- Truck stuck in park... Help!
- Cold Weather
- Led tailights
- pump head bolts
- New guy
- Prolonged cold start exhaust haze?
- fuseable link help what gose where!
- 24 valve tappets
- 92 W250 wheel studs
- What years for parts?
- 5.9 commpression brake coming soon
- question for synthetic oil users
- 1993 Dodge Dually conversion
- holley black lift pump
- Gooseneck Ball and Mounting Plate Question
- Water in the tank, then brakes got hard on my '89
- gotta quit fueling there....
- Replacing manual shut off lever?
- lost all gears, whats your guess?
- 3.07 gears in a 93
- Bilstein 5100 part #
- need some help finding a ve pump
- Christmas Cheer
- fuel gauge issues
- I'm stumped...and nearly broke.
- What's could it be???
- Help identify this truck
- anyone have a lit cabviser
- A Parent's Christmas thoughts
- No Turnsignals or Wipers?
- clutch rebuild: Sachs vs. South Bend
- Shakey Shifter
- babooosssh
- one more ball joint question
- bad or incorrect part thread
- Fuel goes in really slow
- lock out
- Brake light/ flat bed wiring nightmare
- Truck will not turn over, not sure where to start
- brake lights got me stumped
- head gasket replacement
- Im stumped (tranny related)
- NY state laws
- great street tires
- runaway cummins
- turbo and injectors
- before and after
- CTD Ramcharger fuel lines
- injector removal tool
- hazards bad/ turn signals good
- oil in the water
- Thanks for the sticky
- Turbo Question!!!