View Full Version : 1st Gen. Ram - All Topics
- cracked block
- steering return to center
- M&H timing spacer help
- Im new to this so help if you can...mechanical woman with question
- Underbed trans cooler question
- The old girl on the road again
- New 4" exhuast coming
- I hate my truck today... 2 questions-
- Where to get new front bumper 73-80 ?
- I need cost-effective turbo advice.
- Speedo: Old Problem, New Solution
- Cab swap
- What is the best way to install my engine in my truck? with or without transmission
- Transmission temp. guage
- should i buy it???
- what gets wired to the ksb?
- duramax intercooler
- howmuch draw on piston pump?
- boost question
- bed rail protectors
- Which Rancho shock?
- Timing cover seal...
- which Turbo would best soot what im looking for???
- I need a new water pump, have ? or 2
- ok... this took awhile but here are some more videos
- bed cracking
- runaway cummins!
- Piston LP installed
- Widening wheels
- back from my 1st pull in Idaho Falls
- P Pump question
- need help. hope IP isn't going bad.
- Piston Pump-What does the Spacer do?
- Goerend Valve Body
- VE input shaft seal
- free-on
- Rear pinion seal removal
- 65 Mph Defuel
- Fresh Paint
- 4x4
- o-ring head?? Specs/materials
- Need a measurement...harmonic balancer
- 513 gears with 44" and 727 no O.d
- Black Front Grill
- Will someone take a box measurement for me?
- dash removal
- another picture request
- Think I got a blown head gasket...?'s
- widest tire on a 2wd?
- Tires. If Ya Had to Do it Over Again....
- Any first Gen guys running/making their own Biodiesel?
- Brakes/Vacuum issues
- Does 5.9 1992 diesel have liners in them like big trucks?????????
- free p-pump should I take it??
- why is my truck so slow??
- LP Piston pump PSI--
- Shock absorber recomendations?
- Front brake question
- downingtown
- Moving to plentywood Montana
- First Gen Fuel Mileage Thread
- Changing from bed to flatbed possibly?
- Truck won't run after fixing leaking fuel pin!
- 2004 turbo
- How to use a 2nd gen clutch slave on a 1st gen?
- KSB Removal
- hx40
- cheapest turbos??
- body parts
- Power Steering Pump Seal...
- How much actual lift from old saggy leafs to 3 inch leafs?
- back into a first gen!
- pods betters the non i/c sticks??
- IP Question
- 2nd gen lift pump questions, and regulator?
- questions on retorquing head bolts?
- getrag 360 oil
- Help Fuel pickup decision
- Tach with dipswitches
- Anybody else take their 1st gen flying?
- Maxi-Rag
- HX35 Compressor Outlet
- 2wd lift
- New Tranny...Now need speedometer help!!!
- Tach issues
- Pics of 33"s with 6" in lift....
- head "o-ring" ?
- Dad has me at it again!
- 1990 W350 converter purchase
- 1st gen radiator suggestions
- Heater Grid
- I need some quick answers on cab wires!
- You gotta read this....
- pulling motor.
- 91 W350 steering/alignment issues
- Lift pump gaskets...
- Killer dowel pin fix , complete
- 3/8 Inline Fuel Filter won't fill up
- orings
- ECM what years compatable?
- head mag finds its junk!
- I need a quick lesson on how to solder a wiring harness
- Crew died tonight.....
- flow max lift pump by BD???
- >>> TURBO and INTAKE MEASUREMENTs ???
- crossover steering is on!
- paint removal
- I had to put a pull cable in and I hate it!!!!!
- Banjo drama
- Rebuild RH46 or replace w/RH47
- Front shocks to short???
- belt tensioner pulley/wheel?
- New Gm Van project/ custom header
- Saturday Projects...
- HX35 Oil Line Adapter
- Where can one get a replacement harness for the taillight
- quick oil psi question
- no oil pressure.
- clutch fan nut?
- trany rebuild for Getrag
- Dually wheel covers
- getting hot
- Air Ride
- Hotwire the KSB...How?
- I GOT THE SHAFT!!! - Billet 300m TF727 Output Shaft That Is
- New truck maybe
- Auto to Manual swap
- First gen vans?
- Whats the TPS for on an auto?
- Reminder of the Clairmont Roundup
- All i need to do is get the shifter into the getrag and i think I'm done, but...
- FSS trouble
- 518 auto
- brake final solution
- denny t pin for towing
- RH46 vs RH47 identification
- Front fenders
- window felts
- fuel pin
- Fuel screw adjustment pics
- 3rd Geners suck.
- I.c. upgrade?
- Speedo is now off 4-5 mph?
- 518 to 47rh
- Still have a fuel pres problem...
- 4 37x13.50 Toyos IN a Honda Civic?
- Coil Over on our front end ???
- Whats it take to get 400hp
- in need of A/C!!!!
- np205 gear question
- Need some advice: Rear Driveshaft needs modification...
- 14 or 16
- Coolant leak?
- Have been putting my brake issue to the wayside (literally)
- HX35 Question
- Got some slicks
- new sbc wont work
- Smoke screw question
- auto to 5spd wiring question on a 93 W350
- Speedometer repair fiasco
- head gasket repair?
- A couple quick questions.
- Relay Question
- Which Turbo?
- Weird brake issue
- D70 Yoke
- Tire fire
- fuel pin and pyro.
- Need help w/ converion, Any ideas how to make a fuel line with the stock clips
- foam in coolant/fuel in oil
- blown headgasket
- 727 and a518 direct swap?
- Gone n done it
- new truck
- Gear Vendor speedo question
- Undercoating a new bed?
- Lug nut question.......thoughts?
- Pics of fuel system install....
- Got the 3.5" boost tubes done, and alot more work done.......PICS
- another charging issue thread
- Walrbo and Mallory installed!
- 74 Crewcab + 95 4x4 frame + 93 D250 donor project
- cab swap: brake light switch
- Got the Monster ATS Aurora 5000 on...
- Another wobbly steering wheel
- Trans Heating Question
- Dyno talk
- cleaning the I.C.
- wheel studs
- A/C plauge
- Is the A 518 bulletproof?
- Window Exploded Going Down The Hwy
- A/C System Oil
- Switzer S200
- How does the M&H Timing Spacer work??
- Wiring diagram for a 92
- Crank Sensor???
- KDP difference???
- 1993 Ram Cummins 3500 brake proportioning valve ?
- trans help
- How to hook up a boost gauge
- DennyT or m&h
- Eratic idle rpm. plus two other????
- Runaway question
- Power steering fluid temp and pump?
- replace oring with the pump installed dgk-121
- Which way does the coolant flow?
- How to I make it ride smooth (rear)
- Straw install PICS, couple questions
- Not getting full throttle
- Front seal and KDP
- Cummins part # for Tappet cover and gasket
- Shifter
- First Gen all the way!!!
- Water Pump Question
- temp gage
- What do I set my fuel pressure at ?
- 16cm turbo?
- clutch hydros question
- Wow, Best Mod Ever
- getrag trans mount bushings
- Blown HG :(
- The conversion started! Auto to NV4500
- standard trans swap?
- ac
- ve pump seal kit
- Can a faulty Fuel Heater Gasket Suck Air and Not Leak Diesel?
- best place for small parts?
- Heading to the Dyno on Friday
- Stupid question: Which side of clutch to flywheel?
- 1985 Crew Cab Reclaimed
- Another Fuel Pressure ?
- Trans,dont Work First Thing In The Mornig ?????
- new First Gen!!! WooHoo
- shift tower for getrag
- 91 to 98 conversion ??
- Oil centrifuges
- Pics
- Electrical problem.
- callin 1st gen sled pullers, need some advice. im pullin in ID
- 2nd gen 24 valve grid delete same as 1st gen? and what to do with wires?
- Highest EGT's with stock I/C injectors?
- I am starting to be sorry I installed the fass
- Long trip and mpg
- Loaded for the long weekend
- How high is too high?
- 1st gen Power Help
- Non Ic setups with Bigger turbo/sticks??
- ip leaks again!?!
- Reverse Light Switch