View Full Version : 1st Gen. Ram - All Topics
- Making low RPM power?
- downward spiral
- Another OD question
- Major Pros and cons or difference between 1st and 2nd gen motors??
- turbo specs
- chasing hot duramax at pulls, more fuel?
- New first gen
- AC ??'s
- HX35 into an '89...
- 91 Dodge 250 4x4 - good deal?
- Getrag Bearings
- cummins emblems
- Transmission leak
- OD upshift irratic, why?
- Vent Tube Clogged?
- Aurora
- Bhaf
- What engages lockup torque converter? ECM?
- DANA 70 axle/Ladder bar question
- This might be against the law but...............
- Whats an xtended cab long beds wheel base?
- atf
- Stock Parts DO work!!!!!
- The truth about changing your down pipe from stock to 4"
- A/C coil replace
- how much more will my tranny take
- 1999 turbo in a 1992
- Nitrous
- The "DRY Getrag" part Deux
- More ?'s on pump rebuild + options ...
- Dana 70 Widths and normal wheels on dually
- How is this
- Cutting/welding downpipe
- 300hp and 750tq?
- HELP, how to adjust the bands on a A518?
- 93 I/c 5.9
- High RPM Sputter?
- Brakes ?
- chrome bed caps
- AFC question after 3200 spring
- 3200 Spring - Thanks.
- High HP VE Guys
- help my engine blew up
- 12CM bummer
- A/C Control Light.
- Proper lugnut torque: Questionaire
- u-pull-it results from SE PA
- Injector Question.
- shock question
- Tach sensor wire check?
- It ain't here yet
- 3.07 gear swap
- I think I ruined my upper control arm.
- exhaust tip
- Injectors for 240-250 hp
- ok to keep your idle rpm's above normal?
- exaust housing
- I'm New Here...
- Gauges in... results.
- POD guys, what turbos are you running?
- Non I/C Injecters
- Cold Start Solenoid?
- Stupid Brakes!!
- fuel tank filler neck
- to stack or not to stack
- BHAF longevity
- 99 block in 1st Gen??
- speedo drive gear
- Help...this is killing me
- Exhaust Questions
- Which Turbo is this?
- Where to buy tensioner pulley???
- rear end
- Bigragu Cold Air Stock Intake Upgrade
- exhaust temperature thermocouple
- The Cost of a running a DRY Getrag...... :(
- tv cable adjust
- 1st gen winch bumper?
- No HTT for me....
- Did a short burnout....
- Next step, low $$, feel dumb!!
- wastegate adjustment.
- HX-35 swap is done!
- Evolution of computerization on CTD
- Silence is Golden
- Performing Cummins swap, questions.
- silencer ring
- New downpipe for w/g from Stan's
- EGT temps pre/post turbo
- exhaust housing
- Ladder rack and EGTs
- Whose truck is this(video)
- Where to order Outerwears BHAF pre-filter?
- Tranny mods
- weights
- comfortable Cruising speed?
- AFC Torque Specs
- Can't find anybody to work on my Getrag
- Mirror Rechrome
- What speedo gear in Gear Vendors?
- Factory tranny temp sensor, necessary?
- What front suspension?
- 1989 Engine Question From Newbie
- Which transmission do I have ???
- 1991 W250- Which cabs and front clips will work?
- Injection pump options for the VE when rebuilding
- Leaking INJ. pump-fix on or off truck? pic inside...
- How Do you get Injector Pump off??
- Update, long post
- white smoke
- BHAF vs AFE
- Dropping the valvebody...
- Decision on StgIII/16cm
- wannadiesel....filter numbers?
- BHAF - old smokey mount
- What tranny do I have?
- Need advise on a D250 to W250 conversion today!!
- Can a 518 be "made" into a 727
- First up and then down
- fluids spec check, W250
- where to grt stacks for my truck
- High RPM EGT's
- radiator
- 3rd Gen. Turbos
- left upper control arm
- need advice
- Question bout lifted first gens
- any 1st gens in so. utah?
- turbo nut
- 12cm housing limits
- Clutch Advice?
- Cracked flywheel!?
- wait to start light flashing while at highway speeds
- different housing or different turbo
- Which housing should I go with?
- 727 to Getrag Swap Done
- 55 psi !!!!!!!
- automatic to manual trany????
- air filters/ ASA intake?
- Bilstein 5100 help!
- Boneyard trip
- HTT Stage III :-)
- tranny problem
- Banks Intercoolers
- Speed sensor problems
- 21 gone now 16 cm, next?
- Where does the extra spring go?
- 2002 going to 1993..whats the dirt?
- even with a lead foot,very pleased with my mpg's
- running out of fuel?
- 12 cm housing
- HTT Stage IV how-to and impressions
- Donaldson coolant additive
- Cross Flow Rad fit question
- New Guy
- Broken seatbelt receivers
- Stacks and rain
- rims
- gauges
- Anti-freeze
- transmission ? getrag 360 5 speed
- Wheels for W250
- Big exhaust.com question
- Maximum Gauges
- Preventative maintance questions?
- A/C condensation
- Im gas smart but sorta diesel dumb..help me out
- tranny oil preasure
- fuel pin maxed
- stock 91 CTD. i need a little more power
- trans case breaking on a 727??
- 98 turbo in a 92
- Looking at a '92 w/ automatic transmission
- 93 D250
- Front springs
- Air filter
- Transmission Question
- fuel
- Cold air intake
- tranny and oil issues
- Gauges - Everything Explained
- another newbe
- emergence intake air shut down Valve!
- boneyard find
- gauge mounting locations
- air filter
- Chasing a short....Need assistance!
- pics
- local 4" exhaust
- Boost Gauge
- Big Truck Breather
- Trans. Hydraulic lines
- Good/Bad
- What are you guys using to clean stacks?
- 19.5's are on!!!!
- 1979 4 door dually
- tranny
- Adjusted my TPS!
- kdp
- Cab Marker Light location diagram
- AC Cycling switch.
- BHAF..whats the hype?
- balancer difference
- torch out the tailpipe?
- tach
- 1991 w250 info needed
- Tire vs. Rim Size
- dodge body style
- Bench is gone, Buckets are in!
- air bags for front lift?
- fuel leak at the VE pump
- A/C evaperator
- mileage while towing.
- Opinions on new paint
- I need emergency/carry on jack, recommendations?
- Luber-Finer
- Need new tires for 93
- Cab Roof/Marker lights
- Whats the advantage of having a pull cable shutdown?
- 6.9/7.3 IDI Radiator in 91 D350
- gauges
- belt squeal.
- JC Whitney Leafs
- HTT Stg III Sound clips?
- 1991.5 W250 Le
- Fuel Pressure Gauge
- Ramcharger Diesel
- sensor
- Steel bulkhead fitting/ stock fuel tank
- sagging front end
- Do You Need to Press on the Driveshaft Support Pinion?
- Emergency Brake Cable Retaining Clip
- rust on roof
- Sorry Stan's, it did not even come close
- Oil Pressure Sender ???
- 91 cummins with starting problems
- new pump.....truck is a dog.
- Ford rims and Dodge hubcaps, or...?
- Tranny vs. torque conveter slipping
- Cruise control ????'s
- rocker
- Water/Meth questions
- Fuel shutoff solenoid acting wierd
- shut off noise
- Broken fuel guage fix
- Broke the oil pressure sending unit, is it safe to run without?
- 727 4x2 to 4x4?
- Funny turbo sounds?
- Only if it would work?
- pump tweak