- New to Diesels
- timing bump on stock engine good idea???
- Adjustable boost elbow
- Maybe time for a rebuild??
- 47RE leak
- oil leaking between vac pump and ps pump
- Guages
- Why Do HG's Go So Often?
- ton of oil in rad and possible water in oil.
- 94 ctd 618A transmission????
- 8800 lb vs. 10,000 lb. What's the difference?
- difference between frame's.
- 98 12v ECM
- Fuel pressure readings?
- Funny Turbo Noise HX35
- New Brake lines... what type...
- anti freez leak
- whats it take to put a 48re in my truck?
- New mod addition to Project Blacksheep tonite
- 96 cranks but ni start
- Lift pump install questions
- Kody's 97 12 valve build
- digi guage pack
- Pump Will Not Prime Fuel System
- Unusual Surging Problem
- 12 valve intercoolers......
- grid heater elements
- Replacing fuel lines
- Help with starting problem
- Put the truck in D and won't move.......
- Need some help with fluids!
- Driving up the ALCAN to Alaska, '94 Dodge.
- Lift pump- OEM or Aftermarket?
- Clogged Crankcase breather?
- 4X4 front end full time to part time conversion?
- Cracked a Injector line, and welded it...
- pin hole leak at sending unit
- holding shaft from moving fixing 5th gear
- ID of Block?
- Cummins part number
- Rear axle vent tube
- Fuel Leak?
- Pull Start?
- Need bushing kit for front end 97 4wd 3500
- Intermittant Fuel Solenoid Problem
- 5th gear nut install
- 98 12V started, ran a minute, and died
- how do you advance timing?
- 5 in ex
- Most economical way to get both wheels spinning
- 3.54 or 3.73 is the question???
- ??? Is it real?
- Transmission builder near Tacoma,wa
- Question on Cad axle clutch collar?
- starting crank time??
- GEN light on
- to rebuild turbo or not to rebuild
- New Starter
- lack of power
- what size of bolt do i need
- is it safe to pull fuel plate
- Need help........
- Best injectors to go with.......
- 4 inch turbo back
- V10 to cummins
- bang for buck
- 97 cummis mis with no load
- Can injectors be installed in a parking lot ?
- Thread posted in 24V section by mistake?
- Rear Wheel Cylinder Issues
- 47rh shifting real funny
- New Member and New Truck!!! (pics)
- gearing
- 4" Power Elbow/Downpipe
- 94 2500 4x4
- ECU/ECM/PCU repaired 3 times - Who can repair these things?
- Are 1994 12v any good ?
- 12V Rebuild-Ready to start
- Transmission rebuilder near Oxnard, CA
- Muffler question...
- Removing u-joint bearing caps
- Small diesel leak
- Stock thickness head gasket with mods?
- What made my truck lock up? Pls help
- OD hunting after full throttle
- Please verify method for drop valve method to find Top Dead Center
- Fuel Shutoff Solenoid Operation
- tranny fluid leaking
- ANyone used Cylinder Heads International
- Junkyard hub conversion
- Is it normal for fifth gear to have a slight...
- 350 rear axle hub differences
- axle ID and wheel bearing seal info needed
- Clutch problems
- horse power upgrades
- 47RE no downshift @ deceleration
- gearbox
- has anyone......
- Antifreeze leak
- 3500 Dana 80 axle length question
- Front Shock Replacement question?
- time for a new clutch
- Fuel pressure!!!!
- A touch of disappointment
- Shock choices for a soft riding 2wd
- 180 and 215 gov spring diff??
- Kdp ?
- Best timing for my application??
- Antiwrap bars
- hard start
- 60 lb valve springs?
- 95 2500 4X4 What size is lug studs?
- Need help! 97 12valve
- Interesting....
- Opinions please.....Looking to possibly buy this truck.......
- Temp guage and 300rpm idle....
- Just found another great 12valve deal like my truck if anyone needs it
- 12 valve running backwards
- Death wobble
- Newbie--What do I look for when buying??
- anyone runnig 19.5 wheels on 97 dodge
- Brand new member, brand new(seasoned) truck
- Was under the truck today and noticed a purple tag...
- Harmonic Balancer
- Need help with low boost and higher egt
- stumped, advice please
- oil pan drain plug size for timing procedure?
- Pulling out the Transmission need advice
- Borgeson or Redhead power steering gear?
- 8 lug 15" rims?
- Tranny temp gauge install question
- 98 TC in a 96 2500????
- Another lift pump in a year with low miles driven!!! Argh!
- torque spec ex manifold ?
- Renting timing tools?
- Oil Leak
- Cad...
- T-Case to trans studs
- Grinding noise help
- sparks from front balancer
- Where'd My Clutch Go?
- Need help with AFC mod/tuning in Northern/Central CA...
- Lift pumps have a check valve?
- exhaust manifold gasket "burnout!!"
- Got one.......
- Fuel Pressure...too much?
- fuel tank connectors
- Need a pcm for a '96 Auto 4x4
- Ready to do the KDP investigation today...
- Turbo ID and Clutch Application Question
- Duro 12 ply
- some questions on cyl head porting / best places to buy
- Prime-Loc Question
- Runs fine, then spudders and stalls.
- injection pump ticking
- Wondering about power band?
- Hard fuel return line question..
- Brake troubles
- Driveline noise and clunking
- tranny swap. now no od. trans temp light on
- Looking at a 94 3500 dually with auto and???
- Major turbo problem. Help needed! (pics)
- 94 Dually to single rear axle
- injecter suggestions ?
- Has anyone tried putting 3500 drums on a 2500
- Part# needed for injector line
- lockup is a little funny
- Source of Blue when cold engine?
- p-pump id help needed.
- Hard line from LP to filter.... (HELP!)
- Revisiting whether I need a new IP (P-Pump) or not 98 12Valve
- Looking into a '98 12valve 5speed
- Is http://www.dodgeram.org/tech/ Down for good?
- Aftermarket cam, zinc additive?
- You know that '97 I was bragging about buying
- hard cranking
- Boost Question
- greasing upper ball joints?
- Finally gotta Dodge
- Waste Gate Tube to IP
- tranny problems
- p pump sticking
- Replacing the OD solenoid in 47rh
- Cat. convertor replacement ( test ) pipe
- KDP use JB weld?
- Tach Going Crazy
- Code 41 Low ADS relay voltage
- what do you need to check fuel pressure ?
- cummins has a squeal now and then after the kdp
- '96 Automatic transmission will not shift out of 1st
- wastegate explanations sought
- New diesel
- Thanks for the knowledge
- Oil leaking from dipstick??
- TV Cabel
- Front Axle U-Joints
- Power Steering Issues.
- 4wd to 2wd automatic conversion ???s
- Truck barely starts, HELP!!!
- 3rd Gear Issues Before and after Rebuild
- cam / lifter damage, wonder what caused it
- P- Pump Parts Diagram
- need a little knowelage?
- stalling
- Mystery switch Location.....
- High RPM, low load clatter...
- knock/rattle
- Starting Problem
- what the heck is this?
- 95 12valve blue smoke?
- stock boost
- Please help me fix my gas gauge!!!
- Blueprints
- 12v in Dump truck
- i/p
- Who IS running a waste oil mix?
- D70 Power-lock
- speedo gear
- 1994 trans problem
- My 12 valve never warms up, is this ok?
- cutting out at high rpms
- Gauge questions
- problem with turbo
- Exhaust Brake, Can I
- Working on the transmission have questions
- nv4500 lube
- goal-250HP
- low boost after new inline pump
- P7100 removal thread
- tires help please
- 4 wheel drive problem
- Do I need a PCM?
- 2nd gen buying info
- I seems as though there is some info missing in all this tps talk
- Florida Torque Converter
- 90' 12V 5.9L Cummins Power & MPG
- fires right up then dies
- alternator / charge problem
- HELP!! KDP/vibration dampener
- what rpm is a 12v governed at?
- P7100
- wont shift
- best mileage?
- Trans temp sensor location
- Center Driveshaft Support Bearing
- will turbo work
- dying dana 60
- Truck jerking on acceleration/deceleration
- no 5th gear nv4500
- head gasket smoked this AM