- Idle speed ?? Help
- 1992 wont start
- replacing vacuum pump seals
- 4wd Low pops out
- Real time help needed, lift pump install
- Grind/Bind feeling at low speed.
- Towing heavy this weekend--
- Worn Tranny Causing Vibration?
- hard starting '96
- Wrong overflow valve?
- What do you think
- Driveline vibration
- Clutch Slave pushrod cap yea or nay???
- Beginning My Homework Before Buying
- Throttle Springs
- any good trans shops in Sacramento area
- Speedometer Troubles
- 1994 Dodge Ram 2500 Turbodiesel
- Fuel pressure under load?
- rough idle, sticking throttle, blue smoke
- swapping cummins into 77 chevy
- Shudder under accel
- Another overflow valve question
- NV4500 gear question (not fifth!)
- How big does the radiator need to be?
- vehicle speed sensor: permanent magnet?
- Thermostat and small hose on thermostat housing questions?
- Rear main leak
- low fuel pressure at WOT
- AC vs HP
- Trackbar Demand...
- Sheid Injectors?
- KDP and 53 block on a '96?
- Clutch and related questions...
- fuel starvation when temp guage hits normal
- 2inch Lift kit Help
- trans problem 97 12v a/t slips?
- 95 3/4 ton 5.9 gasser, I have questions.
- Quick spool valve
- whats a fair price
- horsepower estimate and questions
- Will a US gear gear splitter affect the ODO/Speedo? Looking at a truck forsale.
- 5 Speed to Auto Trans Swap..... How difficult and $$ ?
- Injector Seal kit?
- How Critical is Valve Adjustment?
- Amsoil 4091
- New overflow valve now low fuel pressure
- speedometer glitch
- vent doors
- Leaky injector?
- changing pick-up hose in tank
- Got Smoked, Need Speed And Hp
- No/low boost
- Dirty pickup screen?
- Help! Need picture of sway bar and end links installed on a 96/97
- 3GSk and fuel plate.
- Front end noise and vibration problem.
- 2000 1 ton
- Help! new brakes SQUELING LOUD
- pic's of fuel plates
- Thermostat Fluctuating
- What else can i do with lil or no money?
- Did the 3 GSK
- Oil getting dirty faster.
- Chirping at idle
- how to check fuel pressure?
- whats a good torque converter?
- Turbo wheel upgrade for 1998 12V?
- feul pressure
- stock filter and line delete?
- Boost leak/ low power
- weird idle issue
- 5th gear nut torque setting.....
- Transmission dip stick tube
- Truck Dies when I let off the throttle
- 12V Fuel System
- fan clutch..and I searched.
- dead speedo
- Exchange 93 5.9 12V IC with 99 V-10
- minor adjustments
- Engine oil leak at Power Steering mount
- Battery drain - where to look first (second, third)?
- 95 cummins kick down lever
- magnoflow 4 inch or ?
- Go pedal has a life of its own!
- Bad governor solenoid/transducer or just low idle??
- How to make a work horse
- dana 80 swap. Parking brake?
- Stiff clutch pedal.... Normal... or not?????
- 1st gen axle in a 2nd gen ?
- Drive shaft length ?'s
- Need Help! Auto to NV5600 Speedometer?
- Lots of smoke want start and wont run? 98 12v
- Injection pump gear nut torque
- Coolant liquids
- valve guide seal? update on this? Keep them down?
- 95 shuts off. need help!
- trans temp gauge
- the pill
- Help Truck wont shut off
- wow - Overflow valve
- Crazy Brakes
- Converting 241HD to fixed yoke?
- Another valve adjustment question
- 47RE Questions...
- new to me '96, what to look for???
- Lift Pump appears to be bad
- Top Speed? How?
- 96 dana 80
- Replace Idler Pulley? And Fan clutch?
- low rpm squeal
- NV4500 Top Cover Question?
- My speedo stopped working
- Front hub conversions
- shopping for injectors
- 95 12 valve...were to start on performance...rookie*
- Burning oil(not as fuel)
- extended crank, hard starting
- PCM causing 2nd gear starts??
- 1994 cummins dies after engine warms
- P7100 failure? How likely at 180k and can I install myself....
- no O/D
- abs light on after motor and axel swap now no O/D?
- 98 starting problems
- Torque Converter Questions
- fuel return leak
- Best head gasket...
- Yet another Blowing Oil Thread
- Intermittent Fuel shut-off solenoid issue. Help!
- set timing to 16.5 mileage still sucks
- Valve Adjustment (12 Valve)
- Auto to 5 spd swap
- Heater hose OK to replace blowby tube?
- 12v fass question
- Yes, remove trans cooler check ball, but how?
- Spicer wheel joints where to buy them
- Is this tube supposed to touch the exhuast?
- Lost KDP and cant find it?
- Diff, Transfer Case and tranny fluid change
- A/C Pulley bearings
- 23 to 29 spline????
- high idle
- Best prices on South Bend Clutch ?
- Air Dog on a 12-Valve
- how cheap
- arm from turbo to downpipe
- Drive shaft trouble
- Good 12V???
- whats the normal temp of the coolant? mine is less than 140
- exhaust pipe where to purchase
- 47RH fluid capacity ?
- Blown head gasket?
- Trans temp issues...HELP !
- Transmission problems
- Turbo rebuild
- oil pressure guage? help please.
- Help, I'm Baffled!
- Lubricity Opinions
- Stacks?
- Fuel Pressure Gauge???
- Where is the best deal on a arb air locker?
- new lift pump now no start?
- What's Your Fuel Filter Interval?
- Exhaust options...
- swaping a nv4500 into an auto 4x4
- automatic or 5 speed need advice
- How does timing affect power?
- kdp fix now front crank seal leaking
- 12 valve or 24 valve
- Leaking Oil Filter Housing/Water Bleed Lever
- Getting Air
- pro torque converter
- Checking Transmission Fluid
- spindle nut?
- 3k gsk downshift issues
- Clutch noise in second gear...
- Hard to start
- Injecton Pump Rebuild
- Will a NV5600 fit 95 12V
- Help with 97
- On Board Air
- inside a California egr intake
- whats with all the KDP talk? please educate me!
- 12v starts then stalls
- throttle linkage
- what fuel plate
- delivery valves
- replaced head gasket now low on power
- 285 75 17's on h2 wheels?
- new to me truck lots of smoke
- Death Wobble REAL bad
- What do you think happened, (long but interesting)?
- No start
- how far to go with timing?
- 94 auto trans wiring 47rh I think
- intake torque specs???
- will not go in gear
- ball joint needs replacing?
- Accurate TDC with a dial indicator...
- sucking air? help
- any aluminum radiators?
- pyro wiring?
- think I killed my flex plate
- Got injured, not killed by the KPD
- 47re shift problems trans tech needed
- 5 speed or 6 speed
- auto trans kills motor
- Engine Mounts
- 97 12v speedo not working
- p7100 starting fuel adjustment
- should i buy this truck????
- another question
- turbo
- another question
- umm...
- "W" terminal or RPM sensor tach feed?
- timing case gasket??
- Sensor name help needed
- truck problems
- tubing from filler neck to tank
- stack
- help
- South Bend Clutch
- just lost 5th gear!!!!
- How to identify 370's
- Motorola 7SP2025 Tach install on 12 valve
- Turbo Feed Line
- 250,000 and kdp has'nt moved at all, but
- Quick Alternator Question
- boost & temp question
- Toggle Switch to lock-up TC
- Noise under load
- rotate TPS
- air flow / cfm ?
- fuel pickup at tank
- brake rotors
- Need help with camshaft
- Algae
- Need your guys input!
- Timing pin, what is this a joke?
- RPM and Speed Problem. Any Ideas?
- Fire ringed head/ stud loose NEED HELP!!!!
- 37337 1-ton wheel cylinders
- front end replacement parts
- 2 oil plugs
- Its....done...almost pictures are up
- No power
- Truck still won't start!
- Transmission Questions
- blow by