- EGT's Too Hot, Is A Silver Bullit The Answer??
- 150 GPH FASS fuel system question?
- I need a little help with some mods
- please help, i need to finish b4 dark!
- lets talk marine gaskets, .010 over, .020 over, which one and why?
- dyno numbers truthful ??
- Polished housing!
- locking hubs
- 215 injectors???
- What twin set up should I use?
- The invincible head gasket is now dead
- Unplugged MAP sensor and LOTS of power, now i'm confused.
- auto hanging second
- S300g Turbo, Where to buy?
- Map Sensor
- lots of guages !!!:o
- Dyno Result using Smarty #3
- hx35/40
- Pray for me....
- Played musical turbos today
- Will a boost leak make the truck sluggish?
- Questions about HTT turbo upgrade
- Studs without bottom tapping?
- Jammer and VB combo
- Wierd Twins question??
- I need a stud tap
- 2001 2WD Front end leveling kit?
- Tst Powermax
- Hx 40?
- the next step
- i want a smarty box
- Towing+Stock turbo+Big injectors??
- Aurora 2000 Turbo?
- which turbo
- i really hate my NV5600
- Torque Converter
- jammer nozzles vs jammer injectors
- Turbo???
- Fuel press gauge question
- turbos
- Ordered Mach 4.5 injectors!
- exhaust flame thrower
- What are the logical steps for building a 24 valve up
- Short bed tool box options please
- Differences between injectors?
- Time for the happy dance...
- brake problem
- turbo
- holley blue pump question
- Is there such a thing as too big of an exhaust?
- Diagnosis help (fuel pressure)
- APPS voltage adjustment
- Question About these injectors
- anybody tried a jumper on the map sensor harness??
- P-pump 24v
- Wire tap box comparison
- Where to go next ?
- No fuel plate?
- info on Hypertech wanted......
- info on Quadzilla wanted.....
- Best place to get FASS-HPFP-95-1002 pump kit
- Pics of Camo accents on truck?
- FP guage install
- High idle flash not working?
- What to ex[ect from build up
- NEW FRNT ROTORS/PADS 3 Q's
- Juice FP pressure problems..
- Anyone use MBRP 5"
- I want some smoke!!!
- Edge, stacked with what!!???.......
- Edge Juice/Attitude stacked w/Bully Dog Triple dog???....
- Hid
- Smarty and Jammers how big?
- well a change of thought.
- Smarty=not impressive
- to tap or not to tap?
- How to install new lift pump?
- fuel pressure sensor help?!?
- Found Chip now what is it?
- Edge Juice/Attitude Questions....
- fuel pump ?
- 650 hp 12v or CR?
- Can a person stack a superhips programmer and a edge ez
- Bully Dog mufflers on exhaust, and downpipes.....
- Difference between cat back and turbo back...
- Megamouth Down pipe, and 6" Straight Pipe questions....
- edge jammer installation
- Towing, Turbo?
- What kind of RPMs?
- Crazy Lift pump idea for a 24 valve......
- more power?
- Fuel pressure hose length needed
- FP test port leak
- ?? for anybody w/a Banks 14cm housing??
- Aeromotive LP AEI-11203 questions
- Turbo Silencer Install
- lap top
- Which PSC Steering Box are u guys running?
- Front Weight Racks Let's See em!
- Thuren Owners?
- 04' turbo on 12 valve?
- 2002 1ton mpg
- Fuel pressure on Juice Q's..
- Juice in, but not tapped yet
- Fuel pump fuel hose?
- Problems with 370's
- isolator for fuel pressure gauge??
- New Era 370's or 435's
- Mopar SureGrip Carrier?
- Transgo kit differences
- Juice install questions, thanks in advance
- Turbo Bark
- Starwheel
- Permanently removing stock LP
- Sweet Tooth Grille?
- What more for 500 rwhp?
- Is Hx40 Enough Air
- juice attitude w/hot program
- what chip
- VP rebuilders
- Pricol replacement bulbs
- Stacking an EZ
- turbo questions
- Hy-35
- New Auto Tranny is in...WOW!
- Turnbuckle it or not turn buckle it?
- what's a 14cm housing worth??
- will this walbro work?
- TST Question 02 to 99?
- Where to purchase Mach injectors from?
- H1C vs. HX35
- OEM Factory Radio
- Where can I get synthetic steering fluid?
- Got the motor out!
- Sliding Stock fuel plate, semi-specific questions
- Stumble when on the go pedal
- Tell me about the TST PM3 COMP.
- F1 Hot Rod 370s OR DDP4s (12 Valve)
- Got a little bit of money..where to start
- APPS voltage adjustment and LSD clutch restack....if you are on the fence...DO IT!
- head studs
- twins Oil lines
- stack question
- Just Installed Fuel Pressure Gauge
- Pyro fitting
- Any issues running ATF as a Fuel additive
- Pics of where you put your Water Nozzles
- ddp or f1
- Edge Juice - Does it really work?
- Mild to Wild.........
- best fuel pressure gauge for the least $$
- Close enough to a #10?
- Vulcan kit question
- 3" body lift...who is good, not super expensive
- Dually mods/pics
- Banks Ottomind & 150hp Jammers
- quadzilla xzt
- stacking chips
- vp-44
- Adjustable Temperature Three Cylinder Idle Idea
- tst or comp stacked on a van aaken?
- Specs on an H2E?
- 6 inch bull haulers
- Best Guages
- fuel plate
- what will cool (egts) my mods??
- mach 6's or 7's
- Will a Holley Blue work with an intank pump??
- silver bullet installed
- fuel pressure guage
- For all those who wanted pics of my 7" tip
- how fast does your truck go?
- High Idle??
- Pics of Line X on lower body
- Pryo Gauge going crazy!
- Truck Video
- Van Aaken CPC R?
- I want more power....
- Lowering a 2500
- EGT Gauge
- exhaust manifold?????
- Quick TST question
- wire tapping??????
- what is a smarty
- biggest lift kit? look inside for full details....
- Boost Elbow?
- best gauge mount
- Loud horn
- How many miles will a vp44 normally last?
- Got the water/meth working
- A Pillar Pod Mounting Issue
- Whats the difference between white and grey PS?
- Whats worked well?
- Part number for HX 35 drain gasket
- What mods to safely tow 30,000 pounds?
- What changes torque powerband ?
- 600hp on vp44 #2 only???
- JL Audio 500/1 and 2 12's ???
- Question about Edge Comp
- 62 or 64 ?
- One of these days....
- Any idea as to what my setup is making?
- 14cm housing or not???
- Quad Commander Fuel Pressure
- quick question on some lingo
- Cummins MudFlaps -- How to mount?
- Need Pyrometer Help
- How much hp?
- 2nd gen 24v vs. 3rd gen at 350hp??
- Bull-Light-Push-Baja Type Bars
- 04 17"alloys 315s on a second gen ???????
- projector, led, halo input for headlights
- to much fuel pressure?
- Van Aaken Smart Box V5 or Diablo Sport Power Puck
- semi wheels opinions please.
- Silencer ring?
- Small NOS kit w/out studs and o-ring head?
- Dock Boy and Farmboy diesel goin at it
- Should my truck lope?
- What shall I do?
- Just installed Vulcan relocat/big line
- Who says Bank$ stuff is outrageously priced!!!!
- Phat shaft 64/12
- New injector nozzles and now hard start
- Looking for a good machine shop
- fire rings
- auto rebuild
- Triple Pillar Pod
- Clutch Disk
- Lift kit
- help my dad
- Buzzing
- G.S.K. through top or side?
- Boost accuracy- block vs manifold
- #8 to #0 plate?
- Pics of 315's!!
- Large Meats
- Power issues
- brush guard install
- Performance injecters
- To drag or not to drag and a turbo question
- Setting the timming on a p7100 pump
- Good (But Cheap) Downpipe
- diy steering stabalizer
- Laser Cut's vs New Era 370's in my truck
- A few afc questions
- Bov
- Trans cooler line/temp gauge question.
- Got it all together and running
- which turbo for my setup?