- What do you think?
- Q's for the quad XZT beta testers
- Suncoast Or Ats Trans.????
- Scotty II Air dam.
- Shocks and lift kits, looking for info
- Making 400 'smoke free' HP with a 12 valve
- leveling kits
- Anybody ever stacked a smarty and Quadzilla ?
- upgrade from 175 to 215 pump
- power puck with RV'S
- FASS vs. A1000
- Does anyone make a hood mounted gauge pod?
- Tranny Gone
- Turbo ?
- Launching in 4wd with a 5spd
- What Do You Need To Beef Up A 47re ?
- Cheap Gauges
- oem fuel filter flow
- Is HX-40 compressor upgrade worth it?
- High EGT's and black smoke
- What turbo would be best?
- 12v timing double check
- Clutch install in D/FW & other ?'s
- DiPricol Gauges...
- I have finally found the best injectors...
- ok here we go
- New Plate Just Arrived
- Can I still drive this with the new driveshaft yoke?
- Does anyone make a slip yoke eliminator for a 241HD?
- anyone have a part # for bosh marine 370s
- ebay headlght review
- Edge EZ interchangeability?
- BD Torque Converters
- Turbos.....what The Heck!!!!!!!!!
- Smarty with HOT Juice
- torque converter
- Help Hooking Up A Fuel Gauge
- Stacking chips...What can I run?
- The Best Headlight Upgrade???
- Need your opinion on these rims
- boost/wastegate hose questions
- if i buy a smarty
- What do you'all think about these hp#s with my set-up
- Stacking
- New Owner
- where to buy afe filters?
- Stacking the chips
- edge comp box defueling
- Advanced the timing...
- Boost Elbow Needed or not
- Wastegate Operation...???
- HD Coil Springs...where???
- Steering Stabilizer
- Stan's Headers in Auburn, WA
- hmmm....
- anyone have the hookup on roadarmor bumpers??
- What causes that "clunk/thud" when stepping on and releasing go-pedal?
- CPS Problems....
- Clutch Install ?'s
- Tuners
- Cupholder Gauge Pod?
- Cam or Sticks?
- Installing A Transmission Temp Gauge
- Dash Gauge Plate
- Bosch 300's
- Air Ride Technologies
- I don't know what I have
- Strobes
- AFE Stage 2
- Stack Heat
- boost and line leaks
- trans temp sensor
- Shifter Knob
- Where to wire the low fuel pressure light?
- What is the diff between a "true" 215HP pump and one that has been "built"?
- Is There a Way To Tell If A VP Has Been Changed??
- *** Do I have??
- Oil Leak???
- turbo to exhaust connection
- Rear Main Leaking Again!!!
- auto to manual swap?
- Flex-A-Lite Fans #262 Installed....
- head studs
- Stacks question
- My thoughts on II HRVP44 ... long
- Cylinder 4,5,6 starved for air?
- Not impressed with my Jammer 5's
- Custom Center Console
- Has anyone run AFE torque tube?
- puck stack
- Super B special, Questons???
- more hp
- SS62 on 24V
- fuel system limits
- Whats The Best Transmission For Drag Racing
- how much tranny do i need?
- Anyone think this would be cool
- What would I need?
- throttle position sensor
- Mileage
- need new Fog lights again,
- Head Mods???
- Quad 4x4 U-Joints...are they Spicer?
- Leveling kit or mild lift?
- My mod for those missing the tire carrier/hoist!
- boost guage
- Proper Install of a Fass on a 12v???
- Best performance mod for the money
- oil leak
- boost pressure & intercooler lines
- 3k gsk on 215 pump
- 2001 w/ Banks Brake - must use Banks exhaust?
- package deal for gauges?
- Thuren just ROCKS! ... question however.
- HTT 62/12turbo, Jammer Vs in 1/8 mile run
- Stalling
- water/meth results??
- Could my timing have slipped?
- intercooler boot
- to 3k gsk or not to 3k gsk
- Exhaust Manifold
- Couple Questions about Oil Pressure gauges!
- Well I reckon I broke a shaft
- Transmisson rebuilt!
- Geno's Garage customer service
- smarty update
- Nekkid girl mud flaps?
- 95 Auto Tranny Problems? Strange??
- O-Ring job
- south bend break in
- Southbend Clutch master squeak
- the clutch I recived from DD southbend
- Twin Turbos and More Fuel
- trans temp installed but its pegged right out
- wastegate question
- Turbo booost 02 auto
- Setting Dana 80 preload and backlash
- Too Much Smoke
- F1 Helix 2 Cam Giveaway
- B&M Hi Tech trans cooler
- Dyno today!!!!
- Found: Item of interest for the drag racers
- How much is stock intercooler good for?
- MBRP 5 inch
- Non wastegated turbo
- Big Line Kit
- Smoke stacks??
- Jammed wastegate?
- Need opinions
- HX40 4" Downpipe, Will It Fit???
- Engine running in Limp Mode with Edge Comp
- Question about spools?
- rim compatibility chevy - dodge?
- AMP Research Power steps
- Slow Spoolup
- MagnaFlow Install & Bad Thoughts About A TX Cowboy....
- 60# valve springs
- Juice w/attitude and speedo question?
- Isspro's and a warning light??
- I dont know anything
- programmer-best bang for buck?
- does smarty stack with edge comp hot box
- Got some new toys!
- Anyone add a remote transmission filter?
- Tst or Edge "Hot"?
- EGTs with stage 5 jammers?
- Dually's with 35" tires (post pics)
- Cold air Filter
- ok, i give up! cant find the data link port connector
- 1 Inch body lift??
- power upgrade
- stock turbo wastegate adjustment
- stacking with edge ez.....
- getting a sbc?
- fass what is this
- Testing a set of full cut dv's on a near stock truck...
- turbo whistle
- low boost numbers
- 191's on the way
- Injector cleaning vs. replacement
- Mmm Delicious!
- help please!!
- Man O Man!!!
- Front Lower Valance
- Average life of a p pump
- Sending my 215 pump to scheid
- Tranny Shop Around DC?
- Who has an aftermarket grill?
- Backspacing ?'s
- Which Turbo?
- how to eliminate torq gard
- Will the tranny take this.
- Info on lift kits?
- II PS 62/12 or II PS 62/14?
- Types Of Fuel Gauges
- FASS question
- pyrometer??
- Head Gaskets
- DYNO numbers
- power puck
- Slicks and BD tranny shafts
- htt 62/13 stainless
- Eadge EZ pulse
- Next phase in building my truck...3 weeks to do it!
- fuel psi gauge...
- Cold Air systems
- New Dodge owner????
- Dana 80 rear options
- Post Pics Of Your Aftermarket Rear Bumper
- Wanted: Pics of 2wds
- Bumper, who makes this?
- O-ringing The Head
- How to tell whats been done?
- Switched VP tap?
- Anyone Use Dipricol Gauges
- Gauge kit? install?
- these cummins are sickkkk
- tapped the wrong wire?
- dual lift pumps
- Posi Lock Questions
- advice for progression
- A/C evaportator
- what to buy??
- LP running 10-15 sec. after truck is turned off!?!?!
- Hit the rollers finally
- Leaky Vulcan Big Line Kit
- Fuel pressure?
- #4 plate
- EGT Help
- dead pedal
- Turbine housing???
- For those of you wanting to know where to hook up your gauge lights...
- How hard to install a turbo timer in a 12v?
- 500 HP 12 valve?
- two graphs same power
- pac brake issues
- Cylinder Block Question
- anyone with pix of Carli, Thuren, Kore....?
- Need a "How To" for my new DV's
- a true "jake brake"
- upgrading the 5sp input shaft for a DD
- what's next???????????
- In Tank Pump fuel pressure
- Got the Comp in my buddies 01, Question!
- Does peak torque range change with #10 plate and 3kgsk?
- Intelligent engineering inc? billet shafts
- isspro gauges done on 95
- Edge Ez question?
- what is a better chip for my 02 for MPG
- well it got me