- Twins down pipe
- 4" vs 5" MBRP
- New Era 435s vs DDP4s RESULTS!!!
- Post pics of trucks with 18" wheels
- Water/meth question
- I finally got my truck lookin' how I want. Before and after pics.
- Suggested upgrade for stock turbo
- #100 plate??????
- FASS and cold weather???
- 191's, 3k gsk, and #5 plate
- 295/75/16 tire availability? need makes
- Can A Silver Bullet????
- Which box = no timing surge?
- transmission
- Georend
- Gauge Question
- Torque Convertor?
- Luke Gold Series Clutch
- Got my Holley blue in
- 4x4 Launch vs 2x4
- Dyno Numbers with Nitro Methane
- Vulcan Draw Straw install instructions
- Holy smokes ! I ordered my Juice!
- LP [verymad]
- Now I know what DV's do...
- Ok so I have a plan... Sorta
- Maximum Boost Levels
- edge comp
- Why do manufacturers change HD models later!!
- Help where to mount the FASS pump?
- Which turbo for twins?
- which turbo
- EGT question?
- propane
- what gauges
- Anyone know where to get.....
- TC Lock-up Switch
- 47RE help
- Heat shield or not?
- Anyone running SW1 with Edge Comp
- Tranny install- new lines=hydraulic hose?
- Ported head with stock cam
- New Pics of my truck
- Transmissions
- AFE Intake
- Holy 5 Inch Exhaust!
- truck did better than I'd hoped on the dyno!
- Delivery valve question
- Couple of things...
- Want list- What order should I get them in?
- anyone make a lowering kit for a 2x4 dodge single cab? how hard
- Oil Lines for twins
- Cheapest way to boost fuel pressure??
- How Much Is To Much!!!!!!!!
- Injector Nozzles install Q? /Advice/
- Walboro system
- off road type front and rear bumpers
- Fuel Leak
- Converting to a auto
- can aney 1 help
- CB Antenna Mounting
- New solution to mounting a gauge pillar in a 2nd gen
- First Impressions of PS62-14
- Disappointing Dyno
- New HRVP is in
- Warn Light Bar?
- Could it be my vp44?
- Guages cost too much...
- Walbro setup?
- A question for those of you with stacks...
- To Dual or not to Dual?
- Is anyone driving dailey with Mach6s and single
- what sizw coils?
- EZ, Smarty or Other?
- intercooler boots
- Will Qzilla Control Edge Comp?
- 5" Exhaust, Cat, and North Carolina
- another METH question
- 2" coil spacer and Monroe shocks
- Installing ps62-14????
- 24V in a Chevy?
- Installed the HTB2
- Bosch Injectors?
- Tell me about BD XXX injectors
- ????Smoke Distribution with Stacks??????
- Flat Black Look vs. Chrome Look
- injector question
- I need a silencer ring...
- Question for Diesel-Dan
- Piccs of DiPricol Optix Gauges on Pillar
- stereo help ASAP PLEASE
- Brakes?
- cold air intake recharge kits?
- Which Gauges???
- Vp 44 code tester?
- Walbro 392 pump in!
- Time for something new...Suggestions?
- dyno guesses....
- LED Tailights & New Headlights
- houston area shops
- F1 VS Jammers
- CB Mount
- cool video
- Fuel Plate problem/delima
- Has anyone used this leveling kit? Thoughts?
- Walbro Lift Pumps, still living?
- boost fooler and elbow
- Mach Injectors???
- boost
- Smarty plus juice?
- 600hp from a 215 pumped 12 valve
- Too much lift pump pressure?
- whos lifted there 2500
- Its Turbo Time
- High volume lift pumps
- Bellhousing Bolt patterns???? 12v vrs. 24v
- Tow Hooks for the front of 1999 D-diesel
- I got some $$ Smarty? Juice, Quad? VA?
- 12V injector claims?
- HTT Pro Street 66 vs Sled puller 66 ?
- TAG air flow guide, is it hype?
- 4in 3rd gen ex elbow on 2nd gen 99?
- need some more power for my 94
- Fueling upgrade question
- Whats Better Juice Or Comp
- Quick Clutch Question???
- 14cm Turbo Exhaust Housing
- brandnew dodge tranny booboo
- 12 valve injecter nozzles?
- stack question, attention blackdiesel
- Help guys she says it's too loud
- edge w/ 01 6speed
- Fuel Pressure Gauge
- gsk
- BD X- Hook
- level 6 setting on edge Q?
- Flex-a-lite electric fan
- New Tranny
- Poll: Quadzilla satisfaction
- 4BT performance mods
- fuel line through firewall...
- All the pieces are falling in place....
- Really, I want the same setup!
- Larger brakes
- tranny temp sensor
- Mack Plug
- Air Suspension
- Camshaft?
- I got my Smarty installed.
- Remote start
- Billet VS Stock shaft difference
- If you had to pick only one mod...
- dv's on 12 valve
- Big Fuel Question
- Western NC Meet
- peter help
- Truck hunts
- holley blue
- Bad Dyno need more power which injectors
- Just got a FP guage on the truck... :(
- another pleased DSS customer...
- Looking for specifc truck pics.
- Horse Power/ Torque
- How many hangers for 5" straight?
- Anybody using a heads up display?
- Anyone running 12 VALVE DDP injectors?
- remote start. Marksman M6A
- High idle flash, what else?
- Need some advice on injectors/nozzles
- 06 shocks on a 96
- Injectors Too Hot?
- Laser Cut Delivery Valves???
- Good solid 350 HP/??? TQ injector and turbo combo???
- plate hp
- Billet Shafts
- ps62-12 or htt62-12 or 14?
- lift pump warranty
- Cap or Tonneau recommendations
- Transmission Mods??
- Smarty...good tow box?
- sellin my stuff
- vp44 warranty ???
- Ideas
- TST mounting???
- another holley blue question
- The great debate...
- Redline Box.. What to stack w/ smarty, drag?
- Stealth Plate?
- what SIZE 16 in.tire for most MPG? not make
- Wait to start light
- Boosted Launches??
- Another Comp Question
- Who has the cheapest 370 injectors?
- Hand Built Exaust
- Just finished my Eberspächer installation
- Walbro 392 Question
- Differential Covers
- fuel pressure lite coming one!
- TS Performance Monitor
- Fuel Filter Change
- the woes of choosing a 66mm turbo
- Surging prob?
- lift pump question
- Injection Pump Timing
- Which turbo is gonna keep my cool?
- Injectors
- htt super stock
- free mods
- What do to to upgrade a 12 valves
- 94-02 Dual Gauge Steering Column???
- New Diesel & MPG
- broken D70 axle shaft
- weight bracket
- checking timing for slippage
- Commander / Recon XZT Fuel Pressure Sending Unit Resolved!
- Holley pump rebuild kit?
- TST PM3 Comp?
- New Track Bar Conversion
- Help me choose wheels!!!
- Where to put the thermocoupler
- p7100 top dead center questions
- exhust brake
- MUST smooth out the ride.
- Aftermarket Transmission Pans
- Trans Rebuild
- Fuel Plate
- What do you think? Ceramic coated stacks
- Just another lift pump discussion.... :)
- Holley blue or black
- "What HP do you want?" (From another thread)
- dd clutch price
- Edge comp Question
- Edge Nozzels
- K&N cleaner/oil work for Airaid???
- Vulcan Kit w/Holley Blue
- FP gauge on 12v?
- upgrade Turbo impeller?
- How to tell if the ECM still has a programmer in it.
- Cummins Missing. Lift pump?
- Holley Blue pump question
- Gsk
- Which Turbo to get?
- falls on face @ 2,700 RPM
- Isspro pyro
- are cummins owners liars?
- Locker for rearend
- front bumber
- Oil pressure gauge for fuel pressure
- front axle?
- Fuel Pressure