- Has anyone extended their breather from up front
- Found my front end clunk
- HD idler arm suggestion
- Freeze plug
- 3.07 gears for my Ram
- Want a Cummins Campain lift pump!
- Silent Recall/Injector Pumps
- Anyone familiar with Dodge part numbers?
- LP bad or good???
- 47RE Stuck in first gear
- Low power at low rpm's
- Inj Pump Question
- Truck runs cooler after towing...
- Braking problems and best deal on HAWK pads?
- 0216 Code Questions
- Changed Fuel Filter: Now that I've got air....
- Does hot weather make smoke or do I have a problem.
- dip stick?
- LP Kit From Cummins
- lift pump?
- P0577
- Tach failed, check engine light then won't start?
- broken exhaust manifold
- diff cover ?
- New Fuel Pump in the tank
- Fuel Pressure ports
- power loss and 237 code, need help!
- Blow By
- RPM's Jump
- Slow to start after long trip
- Batteries, does this make sense????
- Pinion Nut Removal Question
- Alternator/Charging issue
- Something Stranged Happend today.
- turbo
- Fluctuating Idle when Hot
- Tranny shifting
- anyone ever had VP-44 timing error???
- InTank LP. What should I do?
- Question about TPS/APPS
- 99 Torque Converter Clutch (TCC) locking/unlocking in 3rd gear (D)
- New to this site and the Cummins..
- P0236
- 99 diesel (transmission drive-neutral)
- MPG and valve adjustment
- Special Tool To Remove Injectors?
- Code P2106
- Can someone take the time to teach me
- How to get the codes......
- Best price for a VP-44?
- Code read-out
- Junk Carter Lift Pumps
- p0216 code?
- 5spd to 6spd swap
- check engine light after VP44 install?
- Smoke help
- Hard Starts
- Tranny problems? Hope not.
- Front End Alignment...How Hard?
- Truck won't start after fuel filter replacement.
- Block number 23??????
- tps need help
- 5600
- APPS sensor
- Reprogramming ECM
- Lift Pump gone South?
- had my lift pump replaced today.
- How much Fluid's in an Auto Tranny Pan?
- turbo outlet V-band clamp
- Hard starting
- New Member:MPG on my 2002 2500 4x4 is something wrong?
- 2000 Stock
- VP$$ and Tech Facts
- Front Axle Seal
- Variable Geometry Turbo?
- low on the power?
- Reccomendations for valve adjustment.
- A little on the hot side?
- oil leak?
- Engine light
- Clutch??
- Lift pump
- swapping VP44 & dropped pump key!!
- 2002 steering problems
- 99 Cummins just dies
- oil in coolant
- what the heck?
- Smarty on a stock 01-02 HO Motor
- Remote computer VP
- Warranty Question
- Dead Pedal at times
- Hard Pull Today!!!, Trans got little hot
- question ? lift pump convertion
- Stock flywheel weight?
- Strange Starting Problem
- Engine HO or SO 2002?
- buddies 01' truck died tonight????
- How Much Boost?
- Injector Pump?
- need help with 98 to 02 engine swap 5.9L
- Rear wheel abs speed sensor, speedometer and brake pedal..
- master cylinder cap
- Changing Thermostat to the 180 deg
- strange FP problem
- 610/600 ????
- 24V Valve Adjustment
- how long will a vp last
- valve adj really necessary?
- I spy a "55"
- Strange shifting
- 12 inch or 13 inch clutch
- P0123 and P1694
- My Strange Dead Engine Episode
- adjusting valves...where is BDC
- Lift pump PSI question.
- dealer issue with overboost code
- new guy has questions
- long time starting
- Once and for all
- Fuel Pressure Problems Pump Running Intermitently
- Bosch Injection Pump Designed to Fail????
- New to code reading
- Vibration Troubles
- Bypass the ECM? (liftpump)
- transmission problems
- Manual trans Hydraulics???
- 7000 miles on Walbro
- Grinding
- Anyone heard of Wicked Diesels in Virginia?
- 48RE cooling lines, which is which
- Isn't the fuel tank vented????
- High Altitude
- 108 degrees......and here come the VPs'!!
- Hop-Skip-N-Jump
- I'm stumped, need input!
- Idling Problem Need Help
- turbo queastion
- 24V warranty Question
- How long have you left your rig IDLING???
- 24Valve Question
- Thread pitch for VP44 gear?
- ATF Cooler
- VP44 replaced and still stalling
- Factory service manual
- Newbie Auto Tranny Question
- mapp sensor(vp failure)
- Possible 47re Problem; Question?
- Won't start after stopping for lunch..battery?
- Exhaust Manifold Removal
- 01 ho 6 speed?
- overflow valve part number?
- Oil problems
- 2002 drivetrain warranty
- MAP sensor replacement for fuel economy?
- FP drop
- Fuse pannel or ignition switch problem?
- What to expect
- throttle has a mind of its own
- Fuel filter housing on '02???
- Tool to Disconnect Tranny Cooler Lines on 01?
- tranny problems.....help
- 01 fuel psi
- Wet undercarriage???
- Tie Rod Lubing...Seeing grease OK?
- New & need advice on Truck I am looking at
- valve body bolts
- Loss of power in 3rd
- temporary loss of throttle???
- is there a TSB for Tranny shudder in second? how many have?
- What causes black smoke and high temperatures??
- Car Wash = Death Code
- ECM bolt size?
- Dead VP but no code?
- 01 2500
- How do you change a Fuel filter on a 1998 DODGE RAM 2500
- 47 RE won't come out of 1st
- drop to idle
- Nv5600
- 4wd question
- tranny question
- shift point on a auto
- Trans temp
- VP-44 keyway number????
- VP-44 Tamperproof bolts Socket
- Ingition Switch problem ????
- Rear Axle seals
- P0463?
- LP or filter?
- LP loss of pressure while waiting to start?
- Mopar tranny filter and gasket Q?
- Rough brake pedal
- toasted another lift pump and FASS on back order
- Power steering pump?
- Broke my drive shaft today
- question about white smoke and high egt's
- Just wondering...
- Original VP44 or not--- how to tell?
- Front drive shaft
- LP pressure loss when tank is low???
- What to do with used Pressure Plate
- Missing Engine
- engine starts differently after wreck
- Fluid capacity of the NV5600
- 47RE shift problem
- 47re fluid change or flush
- valve chatter
- Grid Heaters
- Bilstein 5100's??
- Exauhst Drone
- vp 44
- VB Installation
- Is a head gasket a hard one?????
- Greasen' her up
- Tell Me If My Clutch Is Toasted
- water in fuel light
- Fuel pressure (this time in the right section)
- Turbo Housing's
- Torque convertor swap
- Bad Mileage - hum from tank
- Resetting APPS?
- Serious help needed here. VP44 probs?
- TPS Trans cable adjustment?
- Auto trans rebuilding
- reading Codes in Cab
- tranny rattling
- 47RE Lock up problems....
- altenator smoke
- Click, Click, Click
- another no-starter
- injection pump pressure
- Rear Axle hub nut
- Vacuum Pump Seal Kit
- Fuel Pressure Question
- Steel Brake Line retailers
- Flooring it only gets me to 2500 RPM ???
- cummins with allison md3060
- vp44/apps/?
- Question about front brakes
- stock 98.5 dodge
- Why am I smelling diesel?
- Can't Get Speed Control System to work
- ECM question's
- Rear Wheelstuds Loose - Cant get tires off
- poor lift pump?????
- where to find what codes mean
- A/C compressor cycling ?
- Fault codes 1693 & 1765
- Lift Pump Location
- camber bushing???
- hose barbs