92 d-350 clutch master cylinder pushrods broke off!
#1
92 d-350 clutch master cylinder pushrods broke off!
1992 dodge d-350 5 speed. Bought a clutch master cylinder from Orilleys about 2 months ago & it's held up good until today when the push rod snapped in half!
The part of the push rod still attached inside master cylinder, & is bent. I have another one on me but I can't for the life of me get the rod out. Can anyone please help me!?!
The part of the push rod still attached inside master cylinder, & is bent. I have another one on me but I can't for the life of me get the rod out. Can anyone please help me!?!
#2
Registered User
I believe they have a rubber grommet on the end that you'll have to pull on hard. Maybe clamp some vise grips on it and smack the grips with a hammer or leverage a pry bar against them?
#3
Registered User
Any I've pulled off, the push rod stayed with the booster. When the booster is shipped, there's a paper keeper on it to keep the push rod in the booster.
You must have some damage to the piston in the MC.
You must have some damage to the piston in the MC.
Thread
Thread Starter
Forum
Replies
Last Post
snoyes
3rd Gen High Performance and Accessories (5.9L Only)
4
04-14-2013 07:34 PM
Gen414
3rd Gen Engine and Drivetrain -> 2003-2007
2
05-07-2009 11:08 AM
cgmorgan06
3rd Gen Engine and Drivetrain -> 2007 and up
3
11-15-2007 04:02 PM
WACTD
3rd Gen Engine and Drivetrain -> 2003-2007
7
07-25-2006 11:41 AM
Fishbait
24 Valve Engine and Drivetrain
10
06-06-2006 12:34 PM