Dodge Diesel - Diesel Truck Resource Forums

 
Page 1 of 20
1
2
3
11
Last »
Search: Posts Made By: Tuckerdee
Showing results 1 to 25 of 500
Search took 0.15 seconds.
Forum: 1st Gen All Products
12-08-2020, 04:13 PM
Replies: 0
Performance & Accessories BHAF mount
Views: 940
Posted By Tuckerdee

BHAF mount

Found one of these I bent up some years back on my shelf. It was made to the dimensions that were going around here on the forum at the time. No holes drilled. Denver area. $40.
...
Forum: 1st Gen. Ram - All Topics
05-22-2013, 11:41 AM
Replies: 116
Views: 218,502
Posted By Tuckerdee

Check your crank position sensor. If the PCM...

Check your crank position sensor. If the PCM doesn't see crank movement it shuts everything else down. Mine went bad and acted the same as yours. My clue was that the Tach (factory) dropped out...
Forum: 1st Gen. Ram - All Topics
10-30-2012, 04:55 PM
Replies: 9
Views: 1,160
Posted By Tuckerdee

Both the throwout bearing and the pilot bearing...

Both the throwout bearing and the pilot bearing are NOT spinning when the clutch is engaged. They would make noise with the clutch disengaged if they were bad, that's with the peddle down.
Forum: 1st Gen. Ram - All Topics
10-30-2012, 02:45 PM
Replies: 9
Views: 1,160
Posted By Tuckerdee

If it makes noise with the clutch OUT then it's...

If it makes noise with the clutch OUT then it's not the throwout bearing. Possibly the input bearing on the transmission. Gurus, what's the bearing in there that's suspect to failure?
Forum: 1st Gen. Ram - All Topics
10-26-2012, 08:32 AM
Replies: 3
Views: 1,591
Posted By Tuckerdee

Turns out I can't get them. They were on a...

Turns out I can't get them. They were on a totaled truck at my work. Insurance won't let us take the tires off. Seems they're worth around $2000!
Forum: 1st Gen. Ram - All Topics
10-25-2012, 09:24 AM
Replies: 3
Views: 1,591
Posted By Tuckerdee

Anybody running 245/75r16's on a 2wd?

I have a chance for a free set. But I'm not sure of how they will work on the 2wd. They are about an inch shorter I believe. So my rpms would be up at cruising speed. Thoughts?
Forum: 1st Gen. Ram - All Topics
10-01-2012, 05:31 PM
Replies: 33
Views: 13,867
Posted By Tuckerdee

Oh, and the transmission shifts are fine. I had...

Oh, and the transmission shifts are fine. I had the transmission rebuilt last spring. And whatever magic they did in there, the shifts were a little bit high for my taste. So now, with the 366...
Forum: 1st Gen. Ram - All Topics
10-01-2012, 05:29 PM
Replies: 33
Views: 13,867
Posted By Tuckerdee

Apwatson, That makes sense! Is there any...

Apwatson,

That makes sense! Is there any evidence that it makes the throttle shaft seal more prone to leaks afterwords?
Forum: 1st Gen. Ram - All Topics
10-01-2012, 10:02 AM
Replies: 33
Views: 13,867
Posted By Tuckerdee

NJTman, I didn't actually have the spring for...

NJTman, I didn't actually have the spring for that long! I had it in my glovebox for about 9 months.

It took me about 4 hours. But I spent a lot of time messing with the low idle screw trying to...
Forum: 1st Gen. Ram - All Topics
09-30-2012, 09:38 PM
Replies: 33
Views: 13,867
Posted By Tuckerdee

Installed the 3200rpm spring and...

Wow. All I can say is why didn't I do this 10 years and 75,000 miles ago? 75-85 is so quick now!
Forum: 1st Gen. Ram - All Topics
09-25-2012, 01:51 PM
Replies: 4
Views: 744
Posted By Tuckerdee

Could be. That crossed my mind also. But it...

Could be. That crossed my mind also. But it would not account for my perceived difference of pedal feel. I'll probably take a look at it anyway since it's so easy to get to.
Forum: 1st Gen. Ram - All Topics
09-25-2012, 06:59 AM
Replies: 4
Views: 744
Posted By Tuckerdee

You may be right j_martin. But I still feel that...

You may be right j_martin. But I still feel that there is some sort of difference in the pedal feel. Personally I'm leaning toward something with the TV valve in the transmission since this problem...
Forum: 1st Gen. Ram - All Topics
09-24-2012, 08:57 AM
Replies: 27
Views: 3,251
Posted By Tuckerdee

Yeah, you're right j_martin. I just thought I'd...

Yeah, you're right j_martin. I just thought I'd share what happened to me to let it sink into the collective consciousness of the board.
Forum: 1st Gen. Ram - All Topics
09-24-2012, 08:42 AM
Replies: 4
Views: 744
Posted By Tuckerdee

Power and Boost are down and intermittant

So. This is confusing issue to me. Maybe not actually. When towing my fifth wheel, something is happening that won't let me get full throttle travel (I think). I normally run a max boost of...
Forum: 1st Gen. Ram - All Topics
09-24-2012, 08:34 AM
Replies: 27
Views: 3,251
Posted By Tuckerdee

I just had this problem. Turned out for me it...

I just had this problem. Turned out for me it was the crankshaft position sensor going bad. Would cut in and out when it heated up to operating temp. The computer couldn't see that the engine was...
Forum: 1st Gen. Ram - All Topics
04-06-2010, 03:12 PM
Replies: 2
Views: 706
Posted By Tuckerdee

Hmm. Hadn't considered that. Makes sense...

Hmm. Hadn't considered that. Makes sense though. Would this mean a new sending/pickup unit or do you think it could be repaired?
Forum: 1st Gen. Ram - All Topics
04-06-2010, 02:16 PM
Replies: 8
Views: 1,109
Posted By Tuckerdee

My EGTs were solid at 1100* with 25 lbs....

My EGTs were solid at 1100* with 25 lbs. sustained boost.
Forum: 1st Gen. Ram - All Topics
04-06-2010, 02:15 PM
Replies: 8
Views: 1,109
Posted By Tuckerdee

Not too bad really. I was just a tick over the...

Not too bad really. I was just a tick over the normal bar on the gauge...whatever that is on our crap-tastic instrumentation.

The barn door gets bigger with the fifth wheel!



Well I've got...
Forum: 1st Gen. Ram - All Topics
04-06-2010, 12:36 PM
Replies: 24
Views: 6,880
Posted By Tuckerdee

Sounds interesting. Post some pics! I'm not...

Sounds interesting. Post some pics! I'm not familiar with centrifugal systems. I've been looking at AmsOil bypass systems, but this price is intriguing me.
Forum: 1st Gen. Ram - All Topics
04-06-2010, 12:34 PM
Replies: 8
Views: 1,109
Posted By Tuckerdee

New rotten mileage record!

Last weekend I pulled my 5th wheel to Lincoln, NE from Brighton, CO. On the way out I had a 100 mile stretch of a pretty good head wind. I'd guess it was around 30 mph. I was full out for that 100...
Forum: 1st Gen. Ram - All Topics
04-06-2010, 12:30 PM
Replies: 2
Views: 706
Posted By Tuckerdee

Blinky "Low Fuel" light

Just got back from a thousand mile trip, and I noticed that my low fuel light seems to blink a lot more than it used to. It used to come on solid and stay on once it came on. Now it just blinks...
Forum: 1st Gen. Ram - All Topics
04-06-2010, 12:27 PM
Replies: 39
Views: 16,836
Posted By Tuckerdee

OK, call me stupid... What are the black bands...

OK, call me stupid... What are the black bands you have around the pipe at the seams? Is it just black paint to cut down on rust at the weld?BTW, very clean!
Forum: 1st Gen. Ram - All Topics
03-25-2010, 04:58 PM
Replies: 190
Views: 71,349
Posted By Tuckerdee

Hey, you have the VERY rare A518/Getrag Combo...

Hey, you have the VERY rare A518/Getrag Combo option. Those were only sold to a few folks that like to row the gears but had Doctor-confirmed knee injuries. I've been looking for one of those....
Forum: 1st Gen. Ram - All Topics
03-22-2010, 03:33 PM
Replies: 46
Views: 4,526
Posted By Tuckerdee

I had that happen to me when I took Jeep into the...

I had that happen to me when I took Jeep into the local dealer for a recall! Quote: "Oh, we had to test drive it." My response: "On lunch hour? with 2 people? 20 miles from your dealship?"
Forum: 1st Gen. Ram - All Topics
03-16-2010, 05:55 PM
Replies: 3
Views: 658
Posted By Tuckerdee

The rear axle identification should be cast into...

The rear axle identification should be cast into one of the webs around the pumpkin. Either on the bottom right, or on the right side webbing going from the axle tube to the pinion. ...
Showing results 1 to 25 of 500
 
Page 1 of 20
1
2
3
11
Last »


 
Forum Jump


All times are GMT -5. The time now is 04:59 PM.