Why Now Help Me out! vp44
new to the site im a member of the idaho bombers forum and this site really could use the help! Well 2 night ago i installed an edge juice w/ attitude. truck fired right up. drove it around for a couple miles to warm it up before i started playin with the chip i started from a stop put it on power level 2 and easily excelerated it was buckin a little kinda thought clutch cuz it prety well shot. came to another stop and put it on power level 3 and got on er pretty good it started buckin really bad so i back out of it quick it died for a sec. then reved up then quit i rolled to a stop and now she wont start at all it does crank over but wont fire. i did some reserch and today i tried some things. first i completly unhooked the chip still nothin. checked lp pressure still very good. then started to undo the injection lines off the back of the Ip and the three i undid seem to have very good presure shootin out of em! then i also undid the return line on the IP and a slight amount of fuel came out. and also the only codes im getting is a 0645 and a 1693 which i had both those codes long before the chip. Any help im nervous its the IP but where its shootin quite a bit a fuel out of it i,m not sure! Any ideas?
__________________

__________________
Yup, sounds like you vac. locked the injector lines. My truck does it regularly when you get off the throttle quickly after a hard run. Crack 3 fuel lines at the head, crank the engine over a bit(5 seconds) then tighten the lines back up and she should fire right up.
Trending Topics
Thread
Thread Starter
Forum
Replies
Last Post
freight train
1st Gen. Ram - All Topics
8
May 28, 2010 02:37 PM
Erska
Performance and Accessories 2nd gen only
17
Mar 6, 2009 09:52 PM



