Pickup bed trailer - what brand?
#1
Registered User
Thread Starter
Join Date: Dec 2004
Location: Between Boulder & Crestone, CO
Posts: 257
Likes: 0
Received 0 Likes
on
0 Posts
Pickup bed trailer - what brand?
Recently bought a pickup bed trailer. Looks like from the 50's or so. I'm curious what brand truck it might be from? It's described in my family blog here:
http://smestdagh.blogspot.com/2006/0...n-trailer.html
Thanks,
steve
http://smestdagh.blogspot.com/2006/0...n-trailer.html
Thanks,
steve
#3
Registered User
Thread Starter
Join Date: Dec 2004
Location: Between Boulder & Crestone, CO
Posts: 257
Likes: 0
Received 0 Likes
on
0 Posts
Fronty, the blog post has a link to a rear view pic also. I'll post it here too:
http://www.flickr.com/photos/s_mestd...n/photostream/
Thanks
http://www.flickr.com/photos/s_mestd...n/photostream/
Thanks
#5
Registered User
It looks much like a chevy box, possibly 58/59, possibly a little later. The fenders have been cut pretty bad, and I know for sure that pre-55 did not have the body line near the top of the fender.
The chevy stepside boxes were pretty much the same design from 47-72, with minor fender changes.
The chevy stepside boxes were pretty much the same design from 47-72, with minor fender changes.
#6
Registered User
Join Date: Aug 2002
Location: Sundre, Alberta
Posts: 1,257
Likes: 0
Received 0 Likes
on
0 Posts
I would lean heavily towards 48 ish Ford. Looks like the bottom rear of the fender has been cut off.
Here is a pic of a stocker......
http://www.hotrodscustomstuff.com/kingCCT.html
Jeff
Here is a pic of a stocker......
http://www.hotrodscustomstuff.com/kingCCT.html
Jeff
#7
Registered User
Thread Starter
Join Date: Dec 2004
Location: Between Boulder & Crestone, CO
Posts: 257
Likes: 0
Received 0 Likes
on
0 Posts
Homestead, I think that's it. See the "line" across the fender in this pic (accessed from the site you sent):
http://www.hotrodscustomstuff.com/ki...ics/KingB1.JPG
That's on my pickup bed also. The back rear of the fender is cut in both height and contour. The front of the fender is cut in height.
I checked the diff bolt circle. It's about 9". I don't know if it's the original though.
Thanks for the ID, Homestead.
-steve
http://www.hotrodscustomstuff.com/ki...ics/KingB1.JPG
That's on my pickup bed also. The back rear of the fender is cut in both height and contour. The front of the fender is cut in height.
I checked the diff bolt circle. It's about 9". I don't know if it's the original though.
Thanks for the ID, Homestead.
-steve
Thread
Thread Starter
Forum
Replies
Last Post
Opus
12 Valve Engine and Drivetrain
4
03-14-2011 01:12 PM
04ctd
Towing and Hauling / RV
3
04-05-2005 11:59 AM