stuck plunger in 1st barrel
Thread Starter
Registered User
Joined: Nov 2005
Posts: 1,597
Likes: 2
From: Mexico!
stuck plunger in 1st barrel
hi
so I bought this p-pump, brought it to an injection shop for calibration...
after we installed it on a 95 truck, it worked great for about 30 miles, thats when all of a sudden it started to rev up by itself, to about 4300 rpm, there was not much to do...Runaway. but then after a while it shut down by itself, and thats where it stayed stuck. could not start the motor again.
I found out that the plunger is stuck in the first barrel. the barrel was a pain to get out. i cleaned, lubricated, nothing helped.
now... is it possible to machine the barrel out a very little bit, to have the plunger just a bit loose in there?
thank you guys
so I bought this p-pump, brought it to an injection shop for calibration...
after we installed it on a 95 truck, it worked great for about 30 miles, thats when all of a sudden it started to rev up by itself, to about 4300 rpm, there was not much to do...Runaway. but then after a while it shut down by itself, and thats where it stayed stuck. could not start the motor again.
I found out that the plunger is stuck in the first barrel. the barrel was a pain to get out. i cleaned, lubricated, nothing helped.
now... is it possible to machine the barrel out a very little bit, to have the plunger just a bit loose in there?
thank you guys
Thread
Thread Starter
Forum
Replies
Last Post
birdboy
3rd Gen Engine and Drivetrain -> 2003-2007
2
Dec 12, 2018 09:02 PM
birdboy
3rd Gen Engine and Drivetrain -> 2003-2007
3
Apr 21, 2012 09:44 PM
Stainless
3rd Gen High Performance and Accessories (5.9L Only)
2
Nov 14, 2007 11:14 PM
