Monty

You guys should get a kick out of this

This truck is in the shop as we speak. Owner just bought it used and was complaining of low power/white smoke and that it wouldnt run over 35mph. This is an ISB in a FL60 (99 model)


In the links below you can see how they have re-routed the injector lines and placed a coupler that is rusting out on #4. There are no clamps at all on the lines and they have taken a piece of paper and stuck it between one of the lines and the head to keep it from rubbing. On #6 they ran it through the engine lift eye.

I just got into the job but I suspect there whole problem will be this as well as an engine harness that is showing bare wire all the way up to the VP pump.

Needless to say....someone didnt know what they were doing.


https://www.dieseltruckresource.com/...cat/500/page/1

https://www.dieseltruckresource.com/...cat/500/page/1

https://www.dieseltruckresource.com/...cat/500/page/1

https://www.dieseltruckresource.com/...cat/500/page/1

wannadiesel

That's some ugly jerry-rigging there, Monty. Didn't the sucker who bought it drive it first?

DPG

Monty, I don't think that I've ever seen such a mess! How could a guy buy an expensive piece of equipment like that and not look under the hood? I would think that even a mechanically challenged individual could see that there is something not right there!

BigBlue

Those are some beautiful lines. I think I'm gonna have that guy bend me up a set for my truck.

Monty

I think he looked under the hood. But, I dont think he knew they werent supposed to be like that.

You can imagine how the truck ran. Reminded me of an old carbed gasser loading up. Had to rev it up to 1100 just to move it or it would die. I sure hope he got a good deal on it. LOL

Haulin_in_Dixie

Looks like good old Alabama Shade Tree work to me.

dodgediesel4x4

Thanks guys for this post, I needed a good laugh today.



Hunter

Scotty

SWEET!

20014x4

A mechanic I worked with did the same thing but with a wiring harness. after the smoke cleared we let him go. I think he moved to Ok. kinda looks like his work.

AaronT

I bet that work was done at NIGHT by a cost reduction engineer.

Monty

Oh yeah, great, send him our way.

20014x4

I think he went to school to be a plumber

Teddroe

I think the guys name was Jerry Rigg

dakar

Even rats would be embarrassed to have thier nests compared to that... hope running lines like that comes with a very stiff fine....

Ryan

I don't think he went to school.