trans- band apply levers
#1
Registered User
Thread Starter
trans- band apply levers
How much slack should they have? Mine will move a fair bit. I would think they shouldn't, but don't have the torque wrench to adjust them.
#2
Guest
Posts: n/a
There should be roughly 5/16" up and down movement and the servo end of the kickdown lever, roughly a third of an inch on the L&R lever at the servo end, if they are sloppier than that I've used a short wrench to tighten them down and then back-off to spec. better to be a hair loose than too tight, more so on the l
&r band, as it doesn't effect shift timing like the kd band.
&r band, as it doesn't effect shift timing like the kd band.
Thread
Thread Starter
Forum
Replies
Last Post
preloader
3rd Gen Engine and Drivetrain -> 2007 and up
6
01-27-2009 05:46 PM