Hey everyone. A friend of mine was asking me about what was available to replace his clutch master & slave cylinder. . . To make a long story shorter, I looked around a little bit & discovered that the listings for '89 -'91 hydraulics, and '91-'93, are different.

I had thought that the hydraulics were the same, or at least similar enough to swap, for all 1st AND 2nd gens -- but a quick search here didn't find me what I was looking for, so maybe I just dreamed that.

Can someone give me a run-down on the differences between the early first gen, late first gen, and second gen parts?

Thanks!

Alec

 

I have not noticed any difference in the 1st gen hydros.
The 2nd gens are different.
I can send you a picture or two of them both Alec.
PM your E-mail if you like.

 

I have a ford master cylinder hooked up to a 1st gen 1991.0 Slave with no problems. The dodge hose and fitting fits the ford. Wouldn't think there is any chance between the 1st gens that matters.

 

Thanks guys!