truck wont start after comp install
truck wont start after comp install
just put my comp in, its got power and the truck wont start. I used the remote wire from my cd player to get power to the box.
Any thoughts, what do people usually do wrong? Even if the wire isnt tapped good it should still start right.
thanks,
Jamie
Any thoughts, what do people usually do wrong? Even if the wire isnt tapped good it should still start right.
thanks,
Jamie
I'd try and retap the wire (although it shouldn't matter but you never know), move the remote wire to a different source (I like the radio fuse in the fuse block), move the ground, and check and recheck all of your connections. Also check to see if you accidentally bumped something while you were running wires and what not.
Aight, I forgot to mention that right before i put the comp in, i was running a smarty from caleb c. and just went back to stock sw. I didnt start the truck after I removed sw 9. everything went fine I thought, the smarty didnt do anything wierd.
BB I give you my deepest regrets............................The idiot in me came out, its actually relieving cause its nothing major. No matter what I try or what smarty sw is programmed, if that harness that goes into the back of the IP isnt plugged in, that truck will not start....................but when you plug it back in it will start
Sorry to waste your time Blue.
Thanks,
Jamie
The official website idiot
Sorry to waste your time Blue.
Thanks,
Jamie
The official website idiot
Trending Topics
dude, caleb I finally got er all put back together and let me tell you, I was impressed. I can slip it in 4th and 5th with the box on kill. If I turn it down to level 4 I can stay in it, EGT's arent too bad as long as im not in it for 30-45 sec.
Overall very impressed, and yes, that box makes real smooth power. And no smarty right now.
Jamie
Overall very impressed, and yes, that box makes real smooth power. And no smarty right now.
Jamie
i lost one of the sealing washers on the inlet side of the lift pump while putting the new lift pump in and did not notice tell i started getting hard starts and then it would not run as i limped in to the shop i noticed the washer on the ground
put it on and tada new truck
put it on and tada new truck
Thread
Thread Starter
Forum
Replies
Last Post
Billwie
3rd Gen High Performance and Accessories (5.9L Only)
8
Oct 5, 2008 06:24 PM
90dodge
1st Gen. Ram - All Topics
31
Apr 8, 2007 07:06 PM



