I just purchased a redline and installed it. When I turn on my ignition it goes through its diagnostics and says "pump connection?'' Does anyone have any ideas on what this might mean the blue chip diesel web site did not offer any information on it. Any help would be great.

 

did you tap the correct wire? the one closest to the block.
Just guessing here, food for thought.

 

Yeah I tapped the right one I am almost possitive

 

btw, what are the power gains on those redline boxes, ive heard too many different claims.

 

I have yet to experience that since it is not hooked up quite right or whatever the problem may be.

 

There are two connections that go to the pump. BOTH of the connections must be correct. The error message is from it not sensing 12v from the pump tap when you turn the key on.

Paul

 

SO, you need to go recheck and possibly disconnect/reconnect the pump connections

 

I have checked both conections and they seem to be fine. I go and check the volts and the selinoid has 12.3 but the apps only has like.4

 

Closed throttle that's what the apps should read. When you measured the pump volts, did you measure between the two pump wires?

Paul

 

I went ahead and sent it back to chip to see if he can get it working or maybe it is something I have done wrong.