I disabled my tq management a while ago on my bully dog and i got the abs, airbag, and emergency braked cel. I turned the tq management back on and i need to know how to clear the cel's. I know its a cycle with your key or something?

 

acook, go to the DTC's and clear codes...even if it says there are no codes, clear out anyway. Should work.

 

Didnt seem to work?

 

Anyone have any ideas?

 

acook, If you have an outlook monitor cut the power to it. I don't mean unplug from the OB11 port. Make sure all lights, cell phone , radio power etc. is off. Do the DTC's test again and clear. cycle the key (don't start) a couple of times. It should work??? This might sound stupid if it doesn't work, put it gear and go backwards for about a 100 ft. or so...That's all I can tell you? It worked for me.

other call BD Monday...Good luck

 

No i dont have the outlook?

 

Did you try driving backwards for about 100' or so applying the brakes?

 

ok so should i clear my dtc's, then start it and drive it back 100 feet, and then hit the brakes?

 

Yes! You may need to go only 60+ try it a couple of times once you have cleared the codes (even if you see no codes) cycle the key a few times after you clear and before you back-up....

 

Ok now whats a cycle, just turning the key on and off a few times, or is it turning it on and waiting a few seconds for everything to shut off like the wait to start light etc...

 

turning it to the run position but don't start. On and off