engine dies and will not start
engine dies and will not start
Last week I ran my truck out of fuel while coming down a canyon in the pasture. put diesel in it and cracked 3 injectors, cranked it over until diesel was pouring out and it has been running fine. then 2 days ago it while coming to a stop light it revved up on its own for jsut a second and when I took off it sputtered and died. It had a Full tank of fuel and I did the same process as above and back to normal again, for now! Any ideas. was thnniking it might be the airdog or the edge, or the Inj pump. I really do not know what to do with this thing anymore! Thanks a million!
No CEL does not always mean there are no codes.
Put the key in the ignition and turn one click. This is the "off" position. The next position is "on". From the "off" position, quickly cycle "on" - "off" - "on" - "off" - "on". Leave it in the "on" position and look at the odomoter. If any codes are stored, they will be displayed. When done, it will read "P done" and go back to the mileage.
Put the key in the ignition and turn one click. This is the "off" position. The next position is "on". From the "off" position, quickly cycle "on" - "off" - "on" - "off" - "on". Leave it in the "on" position and look at the odomoter. If any codes are stored, they will be displayed. When done, it will read "P done" and go back to the mileage.
Thread
Thread Starter
Forum
Replies
Last Post
vintovka
3rd Gen Engine and Drivetrain -> 2003-2007
4
Apr 30, 2012 12:38 PM
jt_gladstone
24 Valve Engine and Drivetrain
2
Aug 9, 2005 11:24 AM



