results of stock pot BHAF install
Thread Starter
Registered User
Joined: Aug 2005
Posts: 319
Likes: 0
From: Nebraska
results of stock pot BHAF install
while I was moving one night 2 weeks ago I hit a deer on a gravel road 
.
But, I had full coverage, and they wrote the check to me since I own the truck. I was fixing the damage to the passengers side lower fender and had the stock airbox out.
And it is still on the shop floor where I left it.
In went the stock pot BHAF and 4" aluminum intake tube and rubber elbows. Looking back it was well worth all the fab time and taking the plasma cutter to the radiator support
. Picked up 3-4 PSI in boost pressure (36 PSI with the stock governor spring ), the turbo lights quicker, and smoke was reduced slightly.
I think I'll tab the KDP this week and swap on the HX35W.
.But, I had full coverage, and they wrote the check to me since I own the truck. I was fixing the damage to the passengers side lower fender and had the stock airbox out.
And it is still on the shop floor where I left it.
In went the stock pot BHAF and 4" aluminum intake tube and rubber elbows. Looking back it was well worth all the fab time and taking the plasma cutter to the radiator support
. Picked up 3-4 PSI in boost pressure (36 PSI with the stock governor spring ), the turbo lights quicker, and smoke was reduced slightly.I think I'll tab the KDP this week and swap on the HX35W.
Thread
Thread Starter
Forum
Replies
Last Post
12von38`s
12 Valve Engine and Drivetrain
1
Feb 25, 2009 10:37 AM