need a couple torque specs for a few bolts on the rear end.
Thread Starter
Registered User
Joined: Oct 2008
Posts: 1,591
Likes: 11
From: Thunder Bay
need a couple torque specs for a few bolts on the rear end.
I need to torque specs for:
the 4 backing plate bolts
8 hub/axle bolts
wheels studs
wheel cylinder bolts.
axle retainer locknut - 120-140 ft lbs, backed off 120 degrees
I appreciate the help thanks guys!
the 4 backing plate bolts
8 hub/axle bolts
wheels studs
wheel cylinder bolts.
axle retainer locknut - 120-140 ft lbs, backed off 120 degrees
I appreciate the help thanks guys!
366 Spring Chicken
Joined: May 2008
Posts: 2,105
Likes: 3
I need to torque specs for:
the 4 backing plate bolts 65 -105 ft lbs
8 hub/axle bolts 55 - 90 ft lbs
wheels studs Coned 175 - 225 ft lbs 5/8 x 18 300 - 350 ft lbs
wheel cylinder bolts. Book says 15 INCH POUNDS Thats not much
axle retainer locknut - As you said, 120 to 140 then back off 1/3rd turn
........
I appreciate the help thanks guys!
the 4 backing plate bolts 65 -105 ft lbs
8 hub/axle bolts 55 - 90 ft lbs
wheels studs Coned 175 - 225 ft lbs 5/8 x 18 300 - 350 ft lbs
wheel cylinder bolts. Book says 15 INCH POUNDS Thats not much
axle retainer locknut - As you said, 120 to 140 then back off 1/3rd turn
........
I appreciate the help thanks guys!
There you go.... Filled in your blanks. Had to get the book out. I just tighten stuff to what feels right.
Adminstrator-ess
Joined: Mar 2003
Posts: 22,594
Likes: 19
From: New Holland, PA
Thread
Thread Starter
Forum
Replies
Last Post
mossyoak11
3rd Gen Engine and Drivetrain -> 2003-2007
2
Feb 6, 2013 10:17 AM
roxxx
1st Gen. Ram - All Topics
8
Dec 17, 2008 10:27 PM
J-DUB
3rd Gen Engine and Drivetrain -> 2003-2007
2
May 11, 2005 08:26 AM
