To get the input of the NV4500 to fit there is a short narrow section at the end of the input shaft that is supposed to be inserted into the engine with a bushing/bearing on it. When i removed the 47rh there is a metal cover over where the input shaft is supposed to be inserted. how do you remove this cover?

 

I might be mistaken but doesn't the end of the shaft and pilot bearing go in the flywheel?

 

yea i think you are right

 

I reread your post and it sounds like the flexplate is still there.

 

The pilot bearing is in the flywheel on these trucks, not in the crank.