i dont have money to buy fat rims n wheels...but i was wondering if there's some sort of spacer..like 1/2 inch or something i can put behind the wheels to give them a wider looking stance

 

You could do wheel spacers, but I wouldn't recommend them on a 3/4 ton diesel. If one breaks, and they do, you could lose a wheel.

 

They are not cheap either. I would just save my pennies and then get wheels and tires.

 

You could buy new wheels that have less of an inset.

Alot of money.

Mike

 

And when youre driving and loose a wheel, well, that's not too good.

 

And... by adding a spacer, you may run into rubbing problems while turning depending on your tire size.

 

Wait a minute........... I just sold a Dodge 1 ton that had FACTORY "spacers".

These were bolted to the hub and it took a 8 lug 1 ton wheel and were 4 1/2 inches.

Take these off and bolt on a 8 lug 3/4 wheel.... worked for me.


Whats the difference if you do it or the factory does it???

He's only going 1/2 of an inch. I say go for it.