I just put in a new VP44 and put everything back right, and now its not starting. It is getting fuel so i checked for codes and got

P 0122 throtle posistioning sensor volts to low
P 0123 " " high
P 1693 DTC Detected In ECM Or PCM, and is says soething about companion mode ?

Please P.M. if you could help, I need my truck for work

thanks, Dayton

 

i reset the computer and now all i am pulling is the P 1693

 

P 1693 is a compainion code, you will need to get a code reader to pull the actual code. Might be a stupid question but did you bleed all the injector lines and everything?

 

yeah what im going to do is take it apart and put the piston #1 to TDC and then it should be timed, all i did was put the keyway on the injection pump gear at 12 o'clock

 

On the vp44 as long as the keyway and key line up, and you don't shear the key, it makes no difference if you are at 12o or not. I always crack three lines, crank till fuel stops bubbling, tighten them up and it starts right up.

 

The first codes look like the APPS (or TPS) being unplugged- take a real good look at the plug and the cable.

 

Hey yall got her runnin again, thanks for all the help

 

What was it?