Just recieved my AEM Workhorse today to
replace my BHAF. Looks real good. Filter has
twice the area of the Brute Force filter. Holding
it next to my old BHAF , I would say the surface
areas of both filters are about the same.

 

Keep us up to date, I was thinking of ordering one!

 

Just installed it at lunch time at work. I'll
let you know about EGT's and noise when
I drive it home tonoght after work. Fit ,
finish and quality seem to be good.

 

Mine came today also. Did you get the polished or powercoated. can't install mine till i get the rest of the truck back together hopefully by sunday.

 

I got the powder coated. After driving home last night,
I have to say I'm impressed. Alot better throttle response.
Noise has increased over the BHAF , but not that bad. Now
I don't know if this is all just because of the new system,
because my BHAF was on for 1.5 years and 25,000 miles
and could have been getting dirty. Though it didn't look that
bad. I had an Outerwear on it for the first 20,000 miles.
Overall grade: A+

 

Everyone with a BHAF , check it Mine didn't
look that bad , but my truck runs 10 times better with
my new intake setup. Must have been plugged, runs
better with less smoke at low boost. I'm going to have
to remove all my "excessive Smarty smoke" rants now

 

Where did you guys find the best price? I've got one on my BOMB list after a clutch.

 

I got mine at here the powercoated one was back ordered a couple of weeks, so i got the polished.
http://www.hopupracing.com/maccokifordo.html
lot cheaper than anywhere else i found

 

I got mine at Horsepowerfreaks.com

 

Yall had them for a while now, any further comments?

How would ya grade them on sound and looks?

 

I'm still very happy with mine. It does have more turbo noise
than the BHAF it replaced.

 

If i can every get the time to get my truck back together "hopefully by this weekend" I'll report next week.