I went to read and clear a code a couple of weeks ago, but when connected, I couldn't read the display. It looked like the letters were overlapping and display kept scrolling. I could make out "rail" but that's about it.

I PM'd Bob a few days ago but got no response. Anyone else see this?

 

I know this might be a stupid question..........
But was the unit cold...?

 

Mine kinda did the same deal, I just look at the DTC code number. It would be cool to see the scroll slow down a little for the reading impaired

 

Push key # 0. Stops the scrolling for as long as you keep # 0 pressed.

Marco

 

Thanks Marco. I'll look at it today and see if the display is readable when not scrolling. The unit was cool when I connected it.

 

Cool beans, I like learning new stuff first thing in the morning. Thanks Marco.