Count me in. The picture on the first page looks great, but if it had a third pod down low by the dash in a triangle pattern it would be killer. Keep up the great work.

 

Keep you fingers crossed and by the end of October there should be something to show for the effort.

 

now will this be something i can add to my single pillar pod not sure if that was made clear

 

It will be a adder piece to a SRT single pod pillar.

 

I'm interested. I need gauges and was planning a 3-gauge dash mount but I might be convinced to stick with 2 depending on looks. I like the look of the SRT-10 pod but 1 opening was definitely not enought. I'll need pictures before I can commit.

FB

 

Alright Scotty get the other stuff out of their .And get the shop righty tighty and get busy on this plier Gage pod for us all. I'v put my 3 Gage cuby hole one out of my mined for wright now. Good luck Scotty

 

I'm interested too.

 

I was hoping it would have a nice, one piece look like the one in the photo?

 

Wait and see...it will look nice.

 

Hi guys Geno's has a in console gauge mount that goes below the air ***** looks real good the only draw back is you can only get it in a 3 gauge setup. I think you can use a fuel gauge inplace of the trans if you have a stick

 

You have to look away from the road...way down and away from the road to look at a console mount...

 

The Laramie actually have the seat heater switches there. Also agree that's a long way down for a gauge.

 

ttt

 

you can put the driving essentials (EGT/boost) on a dual gauge and SRT-10 pillar. Then put the diagnostics (fuel pressure, temps, maybe oil pressure) gauges in the console.

 

Doug...quit making sense!

Not all like the Westech layout of dual sweeping needles. With a dual a pillar pod, handle still in place, and room for three more in the console, you will have enoug space to run every guage you can think of. In your case, you could have dual EGT guage (pre and post) and Fuel pressure/turbo bost all infront of your eyes!