I have a SBC 3600 12cb with the hydrualics upgrade. My question is is there anyway to adjust this clutch to get it to engage sooner it doesnt engage until the very top of the pedal the hydrualics has an adjuster on the master slave cylinder but all that seems to do is raise and lower the pedal height Ive also tryed shortening the clutch fork slave rod that also doesnt seem to help any. Thanks

 

I think thats where you want it to engage?? Unless its too high to actually engage. The 4 SB clutches I've had were the same way

 

Jesse,
Just nature of the beast..
When they are new they seem to engage higher.
I know when I put the last DD in it engaged higher than the one it replaced.
Messing with the rods wont change the point of engagement.