Need a Tranny pan
Need a Tranny pan
Hi guys, my baby was involved in a in an accident, so was my girlfriend, and the transmission pan was damaged. I have a 2003 2WD and was wondering if anyboby might have one laying around and would wanna sell it. I'm not sure if there are different sizes and haven't had a chance to do much research, I was just kinda feeling around to see if anyone had some input. I found an aftermarket for about $130 and held 4 qts over stock, sounds like a pretty good deal, what do you guys think?
Chuck
Chuck
Get the aftermarket. If you gotta pay for one you might as well get one that will hold extra trans fluid and give your trans a little extra fluid to keep it cooler. The general consensus, I think, is that an aftermarket trans pan will allow your fluid to run about 30 degrees cooler on a hot day.
Sounds like you race a little too, so you should definately go aftermarket, imo.
I have had a Mag-Hytec double deep pan on mine since it's first trans fluid change at 15K miles. Has 125K now. Very happy with it.
..
Sounds like you race a little too, so you should definately go aftermarket, imo.
I have had a Mag-Hytec double deep pan on mine since it's first trans fluid change at 15K miles. Has 125K now. Very happy with it.
..
That looks pretty nice, i found this one for a lot less money. Have you ever heard of it?
http://http://www.thepartsbin.com/ca...smission%20Pan
http://http://www.thepartsbin.com/ca...smission%20Pan
Thanks so much guys, it means a lot to know there are good people out there to help out the less fortunate. Fortunatly i was able to knock out the dented part and mig the hole, which wasn't near as bad as I thought it was. Again thanks,
Chuck
PS if anybody has an extra built tranny laying around, I could use that too

Chuck
PS if anybody has an extra built tranny laying around, I could use that too


Thread
Thread Starter
Forum
Replies
Last Post
EverydayDiesel
24 Valve Engine and Drivetrain
3
Nov 11, 2007 09:33 AM
MrKen
Performance and Accessories 2nd gen only
6
Nov 23, 2006 03:19 PM
bostongsx
12 Valve Engine and Drivetrain
6
Sep 25, 2006 11:25 PM



