I need some help guys, I run a '06 with commander and xillarader II.
I have had the xzt2 out for a while, and replaced today.
Commander has been in the truck all the time. I noticed today that there are upgrades for the Commander.
While initializing the down load to the Commander(after the program said I could connect) - my lap top died !!!!!!
Now when I start the truck the commander glows then dies!
If I try to begin the update again, the computer says "cannot re-set the Commander.
Can this be fixed or am I screwed?????

Any and all comments welcome

 

bump for an answer

 

Call Quad Monday am and I'm sure that their tech support can/will help you. they hve been very gratious for me and even offered to repair my old XZT module out of warranty if I would pay the shipping for it.

Good luck....

 

Thanks donhov, I have only good to say about Quads service - I will be giving them a call.