2 micron fuel filter hunt
Registered User
Joined: Jul 2007
Posts: 522
Likes: 0
From: Weymouth, MA
Registered User
Joined: Jun 2007
Posts: 341
Likes: 0
From: Alaska
I use an Oring that seals fine with the Fleetguard base and Cat 1R0750 filter.
Registered User
Joined: Feb 2004
Posts: 3,640
Likes: 0
From: Surrey BC Canada (it's not that bad eh!)
Registered User
Joined: Jan 2006
Posts: 776
Likes: 1
From: Nickelsville, Va
Same here. I measured the difference between the depth of the fleetguard and CAT filters and it was less than 1/8th of an inch if I remember correctly. Mine went on fine and tightened up like it was supposed to.
Thread Starter
Registered User
Joined: Jul 2007
Posts: 387
Likes: 0
From: Hendersonville, TN
Thanks guys, this is why I love this site. Now, as anyone here run the AD150 or a Fass unit INTO the stock filter unit to keep the fuel heater inline? And if so, is there a 2 micron filter available for it. Any thought? I'm trying to finish this install tomorrow the 16th of Febuary.
Thanks
Thanks
Registered User
Joined: May 2007
Posts: 2,161
Likes: 10
From: Sarasota, FL
Thread Starter
Registered User
Joined: Jul 2007
Posts: 387
Likes: 0
From: Hendersonville, TN
yea high bid,
I saw this on DTR the other day, then it dissappeared from the clasifieds, later that day. Not sure where it went, this must be it.
My AirDog 150 has a 10 Micron on it already, with the water separater. Thanks
I saw this on DTR the other day, then it dissappeared from the clasifieds, later that day. Not sure where it went, this must be it.
My AirDog 150 has a 10 Micron on it already, with the water separater. Thanks
Thread
Thread Starter
Forum
Replies
Last Post
1985cucv
3rd Gen Engine and Drivetrain -> 2003-2007
3
Mar 28, 2009 09:49 AM
03RAM2500
3rd Gen High Performance and Accessories (5.9L Only)
8
Jan 11, 2009 05:21 PM
tweeter
3rd Gen High Performance and Accessories (5.9L Only)
4
Apr 13, 2006 10:54 PM