I got to looking at my back seat for some kind of under seat storage mod and see a pull out cup holder under the front seat center section. Got to looking, and it is on a bracket that can be unbolted and spun around. The problem is that the front of the center seat has a little more overhang than the rear. So, I removed the four rivits that hold the cup holder from the bracket and I used JB Weld to set it in a more forward position to clear the front seat and be able to set a cup in it. But you can drill and rivit it back in place as well.

I am not good at "Before and After" pics, so here is some midway pics and I will post some after pics tomorrow.
http://i285.photobucket.com/albums/l...r/100_1501.jpg

http://i285.photobucket.com/albums/l...r/100_1500.jpg

 

Very nice - free is always good.

 

All done. Not the best of cup holders................but it's FREE!

http://i285.photobucket.com/albums/l...r/100_1502.jpg

http://i285.photobucket.com/albums/l...r/100_1503.jpg

 

Nice mod hotwheel! I wonder if it sticks out to far forward for me to use it with the manual trans. cup holder deally on the floorboard??

 

Neat trick Hotwheelbill, looks like a factory setup.

 

Thanks.

We could call it the Hump Mod.................wait, no!