Got the L/P
Thread Starter
Registered User
Joined: Oct 2005
Posts: 174
Likes: 0
From: Dayton, NJ (temporarily while In USCG on Staten Island)
Got the L/P
Alright, got the LP, gonna change it before leaving the base. Do I need to prime it, or just cycle it a few times and bleed air at filter? Any words of wisdom would be appreciated. stephen
Registered User
Joined: Sep 2005
Posts: 340
Likes: 0
From: UTAH
turn key on, bump starter pump will run for like 30 seconds. Turn key off after pump shuts off count to f turn back on bump starter and let pump run again till end of cycle. turn key off, turn back on a start truck.
Dan
Dan
Thread Starter
Registered User
Joined: Oct 2005
Posts: 174
Likes: 0
From: Dayton, NJ (temporarily while In USCG on Staten Island)
installed pump last night, not as bad as I thought, just tough in a parking lot with an almost dead flashlight 
. changed F/O filter while there, ran truck, 15psi at idle, 11-12psi on highway at 70, 10psi pulling the goethals bridge which is a pretty good climb. Thanks for all the help, wish I could buy yall a beer. 
. changed F/O filter while there, ran truck, 15psi at idle, 11-12psi on highway at 70, 10psi pulling the goethals bridge which is a pretty good climb. Thanks for all the help, wish I could buy yall a beer.
Thread
Thread Starter
Forum
Replies
Last Post
Dale M
3rd Gen High Performance and Accessories (6.7L Only)
4
Mar 5, 2011 03:40 PM
bhoff1175
1st Gen. Ram - All Topics
3
Jun 7, 2006 10:19 PM
joel
3rd Generation Ram - Non Drivetrain - All Years
2
May 23, 2003 07:02 AM
