2002 6 speed tries to keep going fwd at a stop light. i.e., Clutch not engaging 100% intermittently. fluid is full. Is it the Clutch cylinder? clutch? how difficult is that to change? any troubleshooting I can do to get to root of problem

 

Master cylinder bleeding off... common problem. You can replace just the master cylinder by driving out the roll pin where the line hooks up...

 

the master cyclinder being the cylinder holding the hydraulic fluid?

Thanks for the reply

 

Master is at the firewall. make sure to bleed the system or you will have a squeshy pedal. I know its not a cheap route but this is the best time to go ahead and upgrade your hydraulics.

 

It could also be the slave cylinder
They are hard to bleed I suggest getting a prebled setup master & slave combo and do not separate them while installing