tranny mount pic
#1
Unless it's untaxed, then it's red.
Thread Starter
Join Date: Aug 2009
Location: Damascus MD
Posts: 589
Likes: 0
Received 0 Likes
on
0 Posts
tranny mount pic
Does this look like its bad enough to cause my mystery acceleration vibration?
The rubber feels pretty soft.
The rubber feels pretty soft.
#2
Registered User
It looks pretty good, check the crossmember to make sure its not cracked. Accel vibration is not usually a trans mount, that sounds more like U joint or carrier bearing( although the carrier looks new) make sure all your U joints have angle to them and arent straight or they will vibrate and wear out quicker. Trans mounts usually give a knock when you shut the truck off if they are bad
#3
Unless it's untaxed, then it's red.
Thread Starter
Join Date: Aug 2009
Location: Damascus MD
Posts: 589
Likes: 0
Received 0 Likes
on
0 Posts
I've replaced he carrier bearing, and pushed / pulled all he universal's, no play in there.
What its doing is under normal acceleration around the top of first gear andinto second fear the whole truck starts to shake like km drive over a badly washboarded road. 5 times worse than hitting rumble strips at low speed.
I'm starting to wonder if its from inside the tranny.
What its doing is under normal acceleration around the top of first gear andinto second fear the whole truck starts to shake like km drive over a badly washboarded road. 5 times worse than hitting rumble strips at low speed.
I'm starting to wonder if its from inside the tranny.
Thread
Thread Starter
Forum
Replies
Last Post
J10495T
3rd Gen High Performance and Accessories (5.9L Only)
1
09-21-2011 04:07 PM
DMS1707
3rd Gen High Performance and Accessories (5.9L Only)
23
11-05-2008 12:53 PM
chw
3rd Gen High Performance and Accessories (5.9L Only)
2
12-25-2006 04:30 PM
ckennedy
3rd Gen High Performance and Accessories (5.9L Only)
5
10-18-2004 03:29 PM