Hey everyone!!! ****.... its been a looooong time since ive posted on here... so ive got a little project going.

Im pulling my built 47rh and swapping in a NV4500 with and 1 3/8" input and a 650hp South bend DD clutch, only problem ive come to so far is... will the slave cylinder and M/C from my first gen work with this transmission?? i have the NV4500 tranny and bellhousing. Also i dont have the little rod for the slave cylinder... i can make one but i dont know what lenght they are?? Thanks



Jason

 

Yes, it'll all work just fine.
I can get you the length of the stock pushrod, but you must have the plastic tip that rides in the fork, otherwise it'll wear the fork.

Mark.

 

Thanks for the offer to measure yours, but i actually was able to get one from Southbend, they had extras laying around so they gave me one

Jason