well everyone im home safe and sound from Iraq again and i have to say thanks for all the support and prayers for me and all brothers a sister in harms way Thank you!!

Well now for the help.

While i was gone i orderd a HX35 with a 12cm2wg housing and i was slaping it in yesterday and i was all most done when i went to put the drain tube on it wont fit!!! the WG gets in the way so i was just wondering what some of you guys have done to make this work

Thank Again

Jim

 

bump?

 

Glad you got home safe dude! Umm, I dunno about your drain tube. Remove the WG? There's gotta be an answer on here somewhere....

 

Its been a long time since but I dont remember any problems However mine came off a 1st gen. something is telling me the wastegate bracket gets turned around??

 

im running a non gated 12cm housing, unless youve got large injectors, you can remove the linkage, and tie the valve closed, my housing has no provision for the gate.

 

Ok so I've pulled the turbo back off the truck to look at some other options. Now if the carage is turned it will clear the oil drain ans will work. But I have never seen one like this before

 

hey glad your home safe! i put a hx35 off a 97 cummins on my truck and everything fit fine. the only problem i had was the down pipe sit further back toward the cab. good luck with it man!

 

Pics?

 

I got it all put on last night. I don't think the HX35 was not off a truck. It had the wrong wg bracket. So I took off the wg and wired it shut lol and boy will that turbo lite!! Not pushing it to hard I pulled 30psi easy.

I will post new pic of the engine bay a little later lol

 

here are some pics of the new stuff under my hood










A 4" exhaust system with a 5" tip went in to, but not in the pics

 

boy those pics make the engine bay look way better then it really is lol