I've got everything off my pump and ready to rebuild but one stupid bolt I cant get too and someone ran off with my 13mm S-wrench. Anyone in the houston or katy area able to tell me where to get one ASAP or give me a helping hand?

 

If You Are Refering To The Nut At Bottom Of Pump That Holds To The Front Cover Just Make One We Just Took My Pump Off And Took A 13mm Wrench And Cut It Down And Use Box End Becuase We Did Not Have Stubby Wrench So Made One Work Great

 

I took a wrench and heated it up and made curve and it worked great..

 

If you cant find one, we carry them at the vw shop I work at, I can set you up with one... If you end up having to buy one. Ours is US made and around $30 though.

Jason

 

PM sent, thanks.

 

Harbor Freight have got a new set of five Metric S-wrenches in new style packaging and a little better quality than the ones they dis-continued.

These new sets have a different SKU-number from the old ones.

These are so new that they are not yet listed on their site, but they have been in the catalogs for a couple months.

 

I called all the Harbor Freight's in the area a few days ago and none had then in stock, and all they could find was a set of curved wrenches shaped like a C, and that wouldnt work.

I have a couple welders and metal fab tools but the only torch to speak of is a small propane that wouldnt help me bend a wrench. I need to get a good cutting torch setup one of these days.

 

www.snapon.com. SP144 is the pump wrench, order online.

 

http://buy1.snapon.com/catalog/item....&group_ID=1288

Is this one for adjusting the idle?

 

I just bought a set from craftsman (10-13 mm) ratcheting u-bends for $30, it was worth it to me...

 

That'd work nicely.