Does anyone got a good source for the 70 Yoke and Joint? And is there any "upgrade" to be done, since I need to replace it?
Thanks In Advance
Justin

 

hey-Hey!!!,
I got a replacement from Riverside Gear. It is a forged unit( v cast stock ), and it has U-bolts instead of straps. Haven't got the rear assembled yet( going to a 3.07 with Power-Lok from an open 4.10 ). It is a fine looking piece. The D60 takes the same yoke as the D70.

The U-Joint should be a 1410( 1-3/16" diameter caps and 4-3/16" end to end, this you can measure with a scale ).
http://www.dennysdriveshaft.com/p472...sel_pick_.html
cheers,
Douglas