Valair replacement OEM clutch quesiton
#1
Valair replacement OEM clutch quesiton
I am considering the Valair NMU70119 OEM style clutch for my 95 2wd 3500. The only place I can find this message is on their website, does anybody know anything about machining the center bore, does it have to be done? Message is below
Attention all 12-1/4" NV4500 and Getrag users.
All 12v trucks will need the center bore machined out.
All flywheels must be checked, we have seen some 24v trucks that have had the 12v flywheel.
Attention all 12-1/4" NV4500 and Getrag users.
All 12v trucks will need the center bore machined out.
All flywheels must be checked, we have seen some 24v trucks that have had the 12v flywheel.
Thread
Thread Starter
Forum
Replies
Last Post
Backwoods Bumpers
24 Valve Engine and Drivetrain
6
11-20-2007 08:01 AM
jmccart
3rd Gen High Performance and Accessories (5.9L Only)
3
05-30-2007 09:39 PM
jmccart
3rd Gen High Performance and Accessories (5.9L Only)
3
05-28-2007 06:53 PM
jmccart
3rd Gen High Performance and Accessories (5.9L Only)
2
12-21-2006 05:28 AM