Hey guys have a question about my drivetrain. While driving I can barely tap the pedal and my truck will act like a buckin bronc, you have to be very carefully with it. Even when you set the cruise and then hit the brake to slow down feels kinda jerky. I just had it completely re done about 15,000 miles ago, the works, clutch,syncrhos,fully splined main shaft, the full meal deal. What would cause this jerkyness. I replaced the throttle cable because it was fryed and helped very litte for awhile but that was 40,000 miles ago.

 

How are the universal joints in the driveshaft?

 

They seem to be fine. I don't know exactly what to look for though. When I get underneath and move the drive shaft there is quite a bit of play, when you rotate it.

 

Check that both of your throttle return springs are there and hooked at each end.

 

If you have a governor spring kit, it's probably adjusted too tight. Try backing off a click or two.
Andy

 

OK checked the throttle springs and only saw one don't know where the other is?,and I don't have a GSK kit.

 

There should be two springs right next to each other.

 

Everything is there, do you have any other suggestions.

 

Here you go

 

I will try to get one, and see what happens. Thank you guys so much for the patience and advice.