OutlawStorm

Can anyone tell me what plate number this would be? The guy said it was an 8 but dont look like my 8 i have here,,, the one on the right is a stock plate. Also when i install that new plate, do i adjust the govenor arm up so it touches the tip of the bottom nose,, or do i have it touch near the bottom of the plate? Thanks

infidel

I don't think it's a TST plate, perhaps Banks or ebay homemade.
A little similar to a TST #6 below except with a smoother profile rather than steps (easier to make)


The gov arm should be adjusted to the pointed tip or slightly below it. A plate like this with a tip above the bottom of the plate is where the gov arm adjustment becomes most critical.

OutlawStorm

Ok thanks,,,,, from what i know he bought the plate from a place in canada, its not homemade as its a 1 piece plate. So this plate will most likely take his Auto out soon if he pushes it to hard then? lol like that would ever happen

jlipskoc

IMO Grind it to a 0 and call it quits

OutlawStorm

I would,,,, but he hauls RV Trailers everyday with it,, and I am sure with a 0 plate his EGTs would run very high,, this way, he should ba a wee bit safer , that is After the the new goerands trans gets put in it lol

ratsun

Outlaw
That plate looks like the one that was in my 180 pump when I got the truck and I was told by the PO that BD in Abbotsford tuned up the pump. I would guess its a BD #8

TxDiesel007

Looks identical to a banks plate pic in my gallery


I dont think its an 8, ive been told its more like an 11, I never knew for sure, Instead i sold it not too long ago..

Rick

displacedtexan

When I saw the pic I thought it looked like your Banks plate Rick!

I have also heard the the Banks plate is pretty much an 11...