KDP Done
#1
Chapter President
Thread Starter
KDP Done
Wasn't to bad killin that dow pin. Had more trouble with gitting the dang windshild washer bottle off and out of the way. Glad I didnt put it off any longer dow pin was sticking out about 3/8 of an inch. DTR should give a prize for the dow pin that sticks out the farthest without fallin out . Here is a shot of the pin before I smacked it back in. Went ahead and ran the valves had a couple that were off 15-20 thousands. RATTLE RATTLE. fired here up and everything seems ok. The kit I got from TST was good. Everything fit fine and good instructions. All that bending over is hard on a young man. Have to have a little Capt. Morgan to limber me up.
[IMG] [/IMG]
[IMG] [/IMG]
#2
Registered User
Join Date: Feb 2003
Location: Haynesville Ga
Posts: 394
Likes: 0
Received 0 Likes
on
0 Posts
Ain't it a good feeling to know that is taken care of Mine was sticking out about the same as yours, not a good feeling to see that. You may want to check your starter contacts next, if you haven't already.
#3
Chapter President
Thread Starter
Yes it is a Great to have it done. Been tryin for three weeks to get to it. Tried four times pourin me a bed liner but hammered it out, just couldnt get the right texture.
Thread
Thread Starter
Forum
Replies
Last Post
6.7L MegaCab
4th Gen High Performance and Accessories 2010 and Up
30
11-10-2011 10:36 PM
pwrtripls1
1st Gen. Ram - All Topics
7
06-06-2010 10:26 AM
Ramdriver15
HELP!
34
01-24-2007 09:33 AM