cooling mod
#1
cooling mod
A few years ago, I read about a cooling mod (can't find the thread now) done to the rear of the cylinder head or block......a fitting and tube or hose added for improved cooling around cylinder #6. Anyone on here done this? And if so, is it actually worthwhile? I'm doing a clutch swap, so that area will be easily accessible......
#2
Registered User
Basically the heater core attachment around the #5 exhaust side is relocated to the rearmost plug at the #6 exhaust port by swapping the plug for the inlet and shortening the hose.
This is thought to better cool the rear of the head which is in kind of a dead end of the circulation loop.
I was gonna eventually do it because it makes sense to add a little life to the engine, jsut haven't gotten to it.
This is thought to better cool the rear of the head which is in kind of a dead end of the circulation loop.
I was gonna eventually do it because it makes sense to add a little life to the engine, jsut haven't gotten to it.
Thread
Thread Starter
Forum
Replies
Last Post
jmccart
3rd Gen High Performance and Accessories (5.9L Only)
4
12-19-2007 12:49 AM
jamesbfishin
3rd Gen Engine and Drivetrain -> 2003-2007
6
07-07-2007 08:25 PM
wap
3rd Gen High Performance and Accessories (5.9L Only)
14
04-23-2007 06:46 PM
RAMV
3rd Gen High Performance and Accessories (5.9L Only)
9
07-14-2004 12:08 PM