Hub Bearings
#2
Registered User
Does your 03 have the AAM 9.25 front axle, with the sealed unit bearings?
Have some but not much left by the time i got them off. Wasn't real careful as i didn't plan on re-using them and they were a royal PITA, nice and siezed up. Maybe someone else with a little more patience managed to remove a pair without destroying them...
If you find new ones put anti-sieze on during install, then when its time for balljoints they will come right off
Have some but not much left by the time i got them off. Wasn't real careful as i didn't plan on re-using them and they were a royal PITA, nice and siezed up. Maybe someone else with a little more patience managed to remove a pair without destroying them...
If you find new ones put anti-sieze on during install, then when its time for balljoints they will come right off
#3
Registered User
Thread Starter
Join Date: Mar 2002
Location: Ontario
Posts: 110
Likes: 0
Received 0 Likes
on
0 Posts
Hub Bearings
Thanks for the reply I had mine off to replace the u-joints about 2 years ago. When I put them back together I used lots of anti-seize so they should come apart fairly easy
#4
Registered User
I have a set with about 15,000 Kms on them. Bought them from a member here trying to solve a front end vibration. Ended up to be an out of balance front drive shaft.
JR
JR
Thread
Thread Starter
Forum
Replies
Last Post
Mutt68
3rd Gen Engine and Drivetrain -> 2003-2007
2
09-25-2012 12:51 PM